hama 200007 niversal USB-C Notebook Power Supply 92WU Instruction Manual

: June 6, 2024
: Hama

Table of Contents

Operating instruction
Explanation of warning symbols and notes
Package contents
Safety instructions
Start-up and operation
Care and Maintenance
Warranty Disclaimer
Technical data
Service & Support
Read User Manual Online (PDF format)
Download This Manual (PDF format)

hama 200007 niversal USB-C Notebook Power Supply 92WU Instruction Manual

Operating instruction

Explanation of warning symbols and notes

Risk of electric shock
This symbol indicates a risk of electric shock from touching product parts carrying hazardous voltage.

Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

Note
This symbol is used to indicate additional information or important notes.

Package contents

Universal USB-C notebook power supply unit
USB-C cable
These operating instructions

Safety instructions

Use the product only for the intended purpose.
Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
Ensure there is sufficient scope for heat dissipation and ventilation.
Only use the article under moderate climatic conditions.
Do not use the product in areas in which electronic products are not permitted.
Do not use the product in a damp environment and avoid splashing water.
Do not short-circuit the battery of the opened terminal device. There is a risk of explosion.
Protect the product from dirt, moisture and overheating and use it in dry environments only.
Do not drop the product and do not expose it to any major shocks.
Do not operate the product outside the power limits specified in the technical data.
Always pull directly on the plug when disconnecting the cable, never on the cable itself.
Make sure that cables do not pose a tripping hazard or block emergency exits.
Do not bend or crush the cable.
As with all electrical products, this device should be kept out of the reach of children.
Do not modify the device in any way. Doing so voids the warranty.
Keep the packaging material out of the reach of children due to the risk of suffocation.
Dispose of packaging material immediately in accordance with the locally applicable regulations.
Make sure that the connected device meets the requirements for supply through class PS3 power sources. If there is any doubt, ask your device manufacturer.

Risk of electric shock

Do not open the device or continue to operate it if it becomes damaged.
Do not use the product if the AC adapter, adapter cable or power cable is damaged.
Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.

Start-up and operation

Note – mains voltage 100 – 240V
The power supply unit is suitable for mains voltages of 100 – 240 V and therefore can be used worldwide. Please note that a country-specific adapter may be necessary.

Ensure that your notebook requires a supply voltage of 5 V / 9 V/12 V / 15 V / 20 V (+/- 1 Volt).
You can find this information on the original power supply unit or in your terminal device’s operating manual. If necessary, ask the dealer who supplied your terminal device or contact your terminal device manufacturer’s support service.

Warning

Do not use the universal notebook power supply unit if you are unable to definitively determine your terminal device’s supply voltage.
Ensure that the notebook’s total power consumption does not exceed the power supply unit’s rated output of 92W.
Failure to comply with this may cause damage to the universal notebook power supply unit and the connected terminal device!

Note the instructions in your device’s operating manual. If these do not contain any instructions expressly to the contrary, proceed as follows:

Note – Power Delivery

Plug & GO: no additional software required, simply plug in and start: Thanks to Power Delivery/Thunderbolt™ 3/Quick Charge, the voltage and power are adjusted automatically.
Be aware that, for efficient and optimised charging, your terminal device must support the PD (Power Delivery)/TBT3 (Thunderbolt™ 3)/QC (Quick Charge) function.
If you have a large number of PD/TBT3/QC-enabled terminal devices with different firmware updates, it may be that the function is not fully supported.

Warning

Only operate the product from a socket that has been approved for the device. The socket must be installed close to the product and must be easily accessible.
Disconnect the product from the power supply using the On/Off switch – if this is not available, unplug the power cord from the socket.
If using a multi-socket power strip, make sure that the total power consumption of all connected devices does not exceed the power strip’s maximum throughput rating.
Connect the power cord to the power supply unit and your terminal device.
Then connect the mains plug to a properly installed socket.
The terminal device can now be used and switched on / charged.

Note

Disconnect the product from the mains after use.

Care and Maintenance

Note

Disconnect the product from the mains before cleaning.

Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents.
Ensure that no water is able to enter the product.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/ mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Technical data

Ambient temperature: 0°–35° C

Specifications in accordance with Regulation (EU) 2019/1782

Manufacturer’s name or trade mark, commercial registration number and address: Hama, HRA12159, Dresdner Str. 9, 86653 Monheim
Model identifier: 00200007
Input voltage: 100 – 240 V
Input AC frequency: 50 / 60 Hz
Output voltage / Output current/ Output power:
5.0 V DC / 3.0 A/15.0 W
9.0 V DC / 3.0 A/27.0 W
12.0 V DC/3.0 A/36.0 W
15.0 V DC/3.0 A/45.0 W
20.0 V DC / 4.6 A/92.0 W
Average active efficiency: 81.5 %
Efficiency at low load: (10 %) 78.8 %
No-load power consumption: 0.09 W

Note on environmental protection:

After the implementation of the European Directive 2012/19/EU and 2006/66/EU in the national legal system, the following applies: Electric and electronic devices as well as batteries must not be disposed of with household waste. Consumers are obliged by law to return electrical and electronic devices as well as batteries at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. By recycling, reusing the materials or other forms of utilising old devices/Batteries, you are making an important contribution to protecting our environment.