BUTURE BR500 Jump Starter Power Pack User Manual

BUTURE BR500 Jump Starter Power Pack

Package Content

Introduction
Thank you for purchasing SUTURE SR500 car jump starter. Please read the user manual carefully before you start to use the product.

Key Features

• A Powerful Jump Starter : SUTURE SR500 Car Jump Starter can jump starts 12V cars, SUV, truck or van (7.0L petrol or 6.0L diesel engine) in seconds up to 20 times.
• Portable Fast Charger : Ensures the fastest charging efficiency, 4x faster than conventional charger.
• Safety Protection : Premium cells, circuitry and safety features protect you and your device from surge or short circuits.
• 4-IN-1 LED Flashlight: The battery jump starter has a built-in LED flashlight with 4 modes (Lighting/SOS/Strobe/Warning) for emergency and night time use.

Know Your Product

1. Jump Starting Port
2. LED Light
3. Output 1
4. Output2
5. Input
6. Power Switch
7. Battery Indicator

Powerful circuit protection system – Smart Clamps

1. Red jumper cable ( +)
2. Blackjumper cable(-)
3. “Smart Clamp” plug

Getting Started

Charging your Jump Starter

1. Please use a 5V2A/9V2A/12V1.5A adapter to charge the product. (Charging cable is included, adapter is not included)
2. Using a 5V/2A adaptor, it will take approximately 5 hours to fully charge the unit. In order to extend the battery life it is recommended to fully charge the unit every 3-6 months.

Turn On your Jump Starter
Short press the power switch to boot the system, the battery indicator lights will turn on. For energy saving, the system will turn to standby mode if there is no operation within 20 seconds.

LED Light
Long press the power switch more than 3 seconds to turn on the light mode. There are 4 modes which are ON, SOS,Strobe and Warning, simply short press the power switch button to change the 4 modes or turn off the light mode. And you can also press the power switch button for more than 3 seconds to turn off the light mode.

Dual Outputs
This portable jump starter is also equipped with two smart outputs that provide the fastest charging speed(USB1: 5V2.4A/9V2A/12V 1.5A; USB2 – 5V2.1A) for your portable electronic devices, such as phones, tablets, bluetooth earphones, etc

Start your Car

1. lnsert the plug of the smart clip oomplete­ly into the jump starter, the green and red lights flash alternately.
2. Correctly clip the red and black clamps to the electrodes of the car battery (red to positive and black to negative )(The green light stays on)
3. Start the vehicle.
4. When the vehicle is started, remove the jumper cable from the vehicle battery immediately.

In any of the following situations, the smart clamp turns on protection mode

1. battery clamp is reversely connected
   • check whether the clip is reversely connected
2. The clamp is short-circuited
   • check whether two clamps together connect or connect both cable clamps to the same piece of metal

---|---
**** The red light flashes slowly| Back change protection, the voltage of the car battery is higher than 12.6V

• No jump starter needed, the car battery is enough to star your car

**** The red LED flashes quickly| The temperature of the clamp exceeds 65(+/-5)degrees

• remove the clamp until the red green led flash

**** The green light flashes slowly| The voltage of the starter is too low try to replace the startup power supply or change it in time

Charge your Car Battery

1. Use the original smart clip to start the car.
2. DO NOT use this unit if any cable clamp or cord is damaged.
3. Start only for 12V vehicles.or it will cause serous damages to the unit.
4. Do not jump start your car when the BR500 capacity is lower than 30%.
5. Do not connect two clamps together when the starter is powered on. And do not connect both cable clamps to the same piece of metal.
6. If the engine does not start on the first try, disconnect it from the car battery and wait for at least 20 seconds before reconnecting. Maximize three attempts in two minutes.
7. Once the engine is successfully started, disconnect the clamps within 30 seconds.

FAQ & Trouble Shooting

• Q: How to tum off this power pack?
  • A: This power pack will power off automatically when no load or charging is complete.
• Q: What kind of adapter should I use?
  • A: You can use the charger of your phone or tablet..
• Q: How long time to full charge the SUTURE BR500 jump starter?
  • A: About 5 hours through the 5V2A AC adapter.
• Q: How many times can this product start the vehicle with full capacity? A: Up to 20 times.

Care and Maintenance

1. DO NOT put the product under direct sunlight or hot areas.

2. DO NOT drop or knock your car jump starter.

3. DO NOT disassemble the equipment, it may cause damage.

4. DO NOT use chemicals or detergents to clean the product.

5. DO NOT place the products in high temperature environment for long.
   The operating temperature: -20-60C(-4°F-140°F).

6. Check the power of the product at least every three months, and charge the product in time.

Warranty

Our company provides customers with warranty of 24 months from the date of purchase.

Contact US
For additional assistance or warranty cover claim, please contact us: E-Mail: support@ibuture.com

Federal Communication Commission Interference Statement

• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Caution
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Declaration of Conformity

We (Manufacturer is responsible for this declaration)

Ekoo Electronic Co…Ltd. (Company name)
B09.block B.f2.bldg.b,runfeng Pioneer Park.no.973, minzhi Avenue, Minzhi St., Longhua, Shenzhen, CN (Company address) declare under our sole responsibility that the product

• Trade name: BUTURE
• Equipment: Car Jump Starter
• Model No. : BR500 to which this declaration relates is in conformity with the essential requirement set out in the Council Directive on the Approximation of the laws of the Member States relating to LVD Directive(2014/35/EU)

EMC Directive(2014/30/EU) & RoHS(2011/65/EU) product is responsible to affix CE marking, the following standards were applied

• EN 62368-1:2014+A11:2017
• EN 55032:2015+A11:2020
• EN 55035:2017+A11:2020
• IEC62321-3-1:2013
• IEC62321-4:2013 IEC62321-5:2013
• IEC62321-6:2015 IEC62321-7-1:2015
• IEC62321-7-2:2017 IEC62321-8:2017
  • Full Name: George.wang
  • Position: Approbation Manager
  • Signature: George.wang Place/
  • Date: Shenzhen. China/Aug. 18-2021

Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>