Lasko 2264QM 20 High Velocity Floor Fan Instruction Manual
- June 14, 2024
- Lasko
Table of Contents
20″ HIGH VELOCITY FLOOR FAN or
WALLMOUNT FAN
MODEL 2264QM
IMPORTANT INSTRUCTIONS
OPERATING MANUAL
This Fan is for commercial and residential use only. It is not intended to be
used in industrial or agricultural settings.
READ
AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE
PRODUCT DESCRIBED.
PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO
COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE!
Have a Question? Need a Part?
Please Do Not Return Product to Store!
Contact Lasko Customer Service:
1-800-233-0268 Monday-Friday 8AM – 5PM
EST.
WARNING
IMPORTANT SAFETY INFORMATION
When using electrical appliances, basic precautions should always be followed
to reduce the risk of fire, electrical shock and injury to persons, including
the following:
Read
all instructions before using this Fan.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR PERSONAL INJURY, ALWAYS
FOLLOW THESE IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS:
DO NOT use this fan to ventilate areas where flammable liquids or vapors are
used, stored or are present, including paints, gasoline, varnishes, floor
refinishing products or solvents. ALWAYS read and follow all warnings and
instructions on the containers for these products!
ALWAYS be sure the plug fits tightly into the outlet. When plugs fit loosely
into outlets, they may slip partially out of the outlet and create a poor
connection. This may cause outlets to overheat and create a potential fire
hazard. Outlets in this condition should be replaced by a qualified
electrician.
ALWAYS unplug the power cord when servicing, cleaning or moving the Fan. DO
NOT use the ON/OFF switch as the sole means of disconnecting power. NEVER
leave children unattended when the Fan is on or plugged in. ALWAYS turn off
and unplug the Fan when not in use.
BE CERTAIN that the power source for the Fan is 120V AC. DO NOT plug the Fan
into 240V or other power source.
The Blue Plug™ on your Lasko fan is a safety feature. It contains a non-
replaceable safety device (fuse) that should not be removed or tampered with.
To reduce the risk of fire, electric shock and personal injury, DO NOT attempt
to remove, replace, repair or tamper with the originally supplied plug. If the
Fan has stopped functioning, it may be due to the safety device incorporated
in this plug.
THIS FAN HAS A POLARIZED PLUG (one blade is wider than the other). This plug
is designed to fit into the outlet only one way. Match the wide blade to wide
slot in outlet and FULLY INSERT. DO NOT attempt to bypass or defeat this
safety feature. If the plug does not fit in the outlet, consult a qualified
electrician. The outlet may need to be replaced.
CAUTION
- AVOID the use of extension cords, power strips, power taps, outlet style air fresheners or other cord connected device, as these devices may overheat and cause a fire hazard.
- DO NOT route power cord under rugs, carpets, runners or furniture. This may damage the cord or cause it to overheat creating a fire hazard.
- ALWAYS place the Fan on a stable, flat, level surface while in operation to prevent the Fan from overturning.
- NEVER insert or allow fingers or objects to enter grill openings while Fan is in operation or injury and/or damage to the Fan may occur.
- DO N O T block, cover or obstruct air flow to or from the fan while in operation.
- DO NOT use this Fan outdoors or near water or wet locations such as a bath tub, pool or hot tub. Use of this Fan in a wet location may create a shock hazard.
- DO NOT run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- NEVER use a single extension cord to operate more than one Fan or other electrical device.
- DO NOT use this Fan if it has been damaged or is not functioning properly.
- Remote controls for other appliances or electronic equipment can sometimes interfere with the operation of this Fan. If this occurs, move the Fan to another location.
- Keep Fan remote control unit away from chairs and your bed where it may be sat or laid upon and inadvertently turn on the Fan.
- THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).This Fan is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please refer to National Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical requirements for agricultural buildings.
- THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 500 (2008).This Fan is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or local codes or standards relating to electrical requirements for hazardous locations.
NOTICE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and
receiver. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help. The user is cautioned that changes and
modifications made to the equipment without the approval of manufacturer could
void the user’s authority to operate this equipment.
SAVE THESE INSTRUCTIONS
MODEL 2264QM
STAND AND CONTROL BOX ASSEMBLY
(Figures 1 and 2)
FAN CONTROL BOX MUST BE MOUNTED TO STAND BEFORE USING FAN.
-
Carefully remove the Fan from the plastic bag and the carton.
-
Align the two sides of the fan to the stand (Figure 1). By pressing in the stand buttons – push down until they lock in place.
CAUTION: Plastic or rubber tabs, like the feet on this unit, may stick to furniture surfaces and/or hardwood floors. The unit may leave a residue that could darken, stain or leave permanent blemishes on the finish of certain furniture surfaces, including wood surfaces, and/or hardwood floors. -
Remove the holding screw from the rear of the fan control box.
-
Make sure wire from fan control box to motor is outside the stand leg and the grill as shown.
-
Insert the holding screw from the rear of the fan through the hole in the stand leg as shown.(Figure 2)
-
Align the fan control box with the holding screw.
-
Tighten the holding screw by hand. Do not over tighten.
-
Plug the cord set into a 120 volt outlet.
WARNING
Be sure that the plug fits tightly into outlet.
When plugs fit loosely into receptacles, they may slip partially or completely out of the receptacle with only the slight movement of the attached cord. Receptacles in this condition may overheat and pose a serious fire hazard; if covered by a curtain or drape, the fire hazard is even greater. -
Turn the Fan on by selecting the desired speed with the Power Knob on the side of the Fan.
0 – Off
3 – High
2 – Medium
1 – Low -
To adjust the vertical angle, tilt the Fan body forward or backward to the desired position.
|
---|---
QUICKMOUNT® SYSTEM
Your fan may be wall mounted using the new QuickMount® wall bracket supplied with your fan. (Figures 3 and 4)
WALL BRACKET MOUNTING
- Choose a mounting location which will allow installation of hardware (not supplied) directly into wall studs or adequate structural support.
- Using the wall bracket as a template, mark the hole locations on the wall after leveling the bracket.
- Fasten wall bracket to mounting surface using 2 appropriately sized fasteners. Drill pilot holes as necessary. (See Figure 3).
CAUTION: Check for electrical and/or gas lines before installing the wall bracket.
HANGING FAN ON WALL BRACKET
- Hold fan in an upright position, just as it would sit on the floor.
- Place back edge of stand in wall bracket hooks.
- Slowly allow the stand to rotate downward so that rubber feet at front rest against the wall below the mounting bracket.
- Tilt head of fan to desired angle.
MAINTENANCE
To reduce the risk of electrical shock and fire please observe the following instructions:
- Always unplug the cord before moving, servicing or cleaning.
- NEVER place the Fan in or near water.
- Clean the Fan only with a vacuum equipped with a brush attachment; the vacuum will remove the lint and dirt from inside the Fan.
- NEVER attempt to take apart the Fan.
- Clean the body of the Fan with a soft cloth only.
- NEVER use ALCOHOL or SOLVENTS such as gasoline, benzene, paint thinner, or other harsh cleaners.
SERVICING: All other servicing, with the exception of general user-
maintenance, should be performed by an authorized service representative.
STORAGE: Store the Fan with these instructions, in the original carton in
a cool, dry place.
LUBRICATION: Motor is permanently lubricated.
DISPOSITION: Corrugated packaging materials are recyclable. For
environmentally responsible disposal of this product, contact your local waste
service provider or visit www.1800recycling.com®.
SERVICING: For servicing, other than general user maintenance, please
contact Customer Service at
800-233-0268, Monday through Friday,
from 8am-5pm Eastern.
LASKO PRODUCTS, LLC LIMITED WARRANTY
(VALID IN THE USA, ITS TERRITORIES, AND CANADA ONLY)
WHAT THIS WARRANTY COVERS: This product is warranted against defects in
workmanship and/or materials.
HOW LONG THIS WARRANTY LASTS: This warranty extends only to the original
purchaser of the product and lasts for one (1) year from the date of original
purchase or until the original purchaser of the product sells or transfers the
product, whichever first occurs.
WHAT LASKO WILL DO: During the warranty period, Lasko will, at its sole
option, repair or replace any part or parts that prove to be defective or
replace the whole product with the same or comparable model. For all warranty
claims, the product must be returned to Lasko Products, LLC at customer
expense with proof of purchase within the warranty period. Contact the Lasko
customer service department to obtain a Return Authorization (“RA”). DO NOT
return products without an RA or the warranty claim will not be processed.
WHAT THIS WARRANTY DOES NOT COVER: This warranty does not apply if the product
was damaged or failed because of accident, improper handling or operation,
shipping damage, abuse, misuse, unauthorized repairs made or attempted. This
warranty does not cover shipping costs for the return of products to Lasko for
repair or replacement. Lasko will pay return shipping charges from Lasko
following warranty repairs or replacement.
ANY AND ALL WARRANTIES, EXPRESSED OR IMPLIED (INCLUDING, WITHOUT LIMITATION,
ANY IMPLIED WARRANTY OF MERCHANTABILITY), LAST ONE YEAR FROM THE DATE OF
ORIGINAL PURCHASE OR UNTIL THE ORIGINAL PURCHASER OF THE PRODUCT SELLS OR
TRANSFERS THE PRODUCT, WHICHEVER FIRST OCCURS AND IN NO EVENT SHALL LASKO’S
LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY INCLUDE (I) INCIDENTAL OR
CONSEQUENTIAL DAMAGES FROM ANY CAUSE WHATSOEVER, OR (II) REPLACMENT OR REPAIR
OF ANY HOUSE FUSES, CIRCUIT BREAKERS OR RECEPTACLES. NOTWITHSTANDING ANYTHING
TO THE CONTRARY, IN NO EVENT SHALL LASKO’S LIABILITY UNDER ANY EXPRESS OR
IMPLIED WARRANTY EXCEED THE PURCHASE PRICE OF THE PRODUCT AND ANY SUCH
LIABILITY SHALL TERMINATE UPON THE EXPIRATION OF THE WARRANTY PERIOD.
Some states and provinces do not allow limitations on how long an implied
warranty lasts, or the exclusion or limitation of incidental or consequential
damages, so these exclusions or limitations may not apply to you. This
warranty gives you specific legal rights. You may also have other rights which
vary from state to state and province to province.
Proof of purchase is required before a warranty claim will be accepted.
CUSTOMER SERVICE:
Toll-Free 800-233-0268. Email:
producthelp@laskoproducts.com
Our Customer Service team is available to assist you with product and service
questions, and replacement parts.
They can be reached Monday through Friday, 8am-5pm Eastern. Please have your
model number available, as well as
the type and style (located on the underside of your product).
Customer Service Dept., 820 Lincoln Ave., West Chester, PA 19380
(Please do not send product to this location)
www.laskoproducts.com
Manual printed in China
Rev. H 1/18
2264QMES
Rev. H 1/18
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>