Uooka EC100 Drone with Camera Instruction Manual
- June 14, 2024
- Uooka
Table of Contents
Uooka EC100 Drone with Camera
FORBIDDEN:
Special design for indoor & outdoor, please keep it away from obstacles. This
product is suitable for indoor (the wind grade should be not more than 4),
please choose a place without obstacles, and keep your distance from crowds
and pets, don’t play it under unsafely, for instance, heat source, wire or
electronic power source in order not to be damaged by collision landing,
entanglement and lead to a fore, electric shock and cause losses of lives and
property.
DISCLAIMER & WARNINGS
- Please read this disclaimer, warnings, and safety guidelines carefully before using our product. This product is not recommended for people under the age of 14. By using this product, you hereby agree to this disclaimer and signify that you have read it fully. You agree that you are responsible for your own conduct and any damage caused while using this product, and its consequences. You agree to use this product only for purposes that are proper and in accordance with local regulations, terms, and all applicable policies and guidelines we may make available.
- When using this product, please be sure to strictly abide by the specification requirements and safety guidelines stated in this document. Any personal injury property damage, legal disputes, and all other adverse events caused by the violation of the safety instructions or due to any other factor will not be our responsibility.
WARNINGS
- The drone is designed for ages 14+.
- Adult supervision is always advisable with any form of flying toy.
- Always ensure your flight area is free of any obstacles before taking off, and ensure the drone is always flown in excess of 1.5 meters from yourself and others.
- Remove all batteries from the drone and transmitter when not in use.
- Never overcharge the battery.
- Never leave to charge battery unattended.
- Never touch the drone’s motors during or after flight as they can get hot.
- Never touch the propellers when they are rotating.
- If the drone becomes damaged, stop using it immediately.
- Do not dispose of any parts of the drone or transmitter in the normal rubbish, all parts should be taken to your local recycling center.
- The battery in the drone should never be exposed to any form of high temperature or disposed of in a fire.
SAFETY GUIDELINES
Check Before Use
- This product is not a toy, but a high-precision drone that integrates various electronic stability and control mechanisms. Please be sure to set up this drone carefully and correctly to ensure safe, accident-free operation.
- Please be sure that the batteries of the drone and transmitter are clean, undamaged, and have enough power.
- Please be sure that all the propellers are undamaged and are installed in the right orientation.
- Please do a thorough check of the product before each use. Check for firmness of the parts, any signs of cracks and wear of the propeller, battery power, and effectiveness of the product until all the issues have been checked completely.
Safe Flight Environment
- Make sure the surrounding area is free of any people, pets, or other obstacles before you start to fly your drone.
- Your drone is designed for indoor or outdoor use. However, it is not recommended to fly the drone indoors if there is limited space, or outdoors if there is a strong wind.
- Keep a safe flight distance between you and the drone at all times.
Use of Battery
- Please ensure the batteries are fitted in the correct orientation as shown in the instruction manual.
- Avoid short circuits by filing the batteries incorrectly, and do not crush the batteries as this may cause the risk of an explosion.
- Do not mix new and old batteries as this can lead to a poor performance of the product.
- Dispose of used batteries carefully.
- Please keep dead batteries away from heat and fire.
- If the device is not going to be used for a long time, remove the batteries to prevent potential damage from battery leakage.
- It is recommended to only use the original USB charging cable that comes with the drone to charge the battery.
- Don’t connect the battery directly to wall outlets or car cigarette-lighter sockets.
- Don’t attempt to disassemble or modify the battery in any way.
- Don’t use the battery if it gives of an odor, generates heat, becomes discolored or deformed, or appears abnormal in any way. If the battery is in use or being charged, remove it from the device or charger immediately and discontinue use.
Notes:
Please ensure the batteries for the drone and the transmitter are fully
charged before the flight.
Li-Po Battery Disposal & Recycling
Waste Lithium-polymer batteries must not be placed with household trash.
Please contact the local environmental or waste agency the supplier of your
model or your nearest Li-Po battery recycling center.
Maintenance
- Clean the product after each use with a clean, soft cloth.
- Avoid prolonged exposure to direct sunlight and avoid the buildup of heat on the drone or batteries.
- This device is not waterproof and must not be submerged or subjected to water under any circumstance. Failure to keep the device completely dry will result in failure and permanent damage to the unit. Be aware that although it might be dry where you are, droplets of rain or mist from a river or waterfall could damage your drone where ii is flying.
- Frequently check the charging plug and other accessories for signs of damage. If any part of the device or cables is damaged, avoid the use or charging until the device can be serviced.
PACKING LIST
DRONE’S DETAILS
It is crucial that all the propellers are installed in the correct position (Pay attention to the letter A or B printed underneath each propeller).
TRANSMITTER FUNCTIONS
JOYSTICK MODE
INSTALLATION
Protective Rings
- Installation: Insert the protective ring diagonally into the side of the motor base and get it connected with the buckle, then tighten the screw clockwise.
- Removal: Counterclockwise unscrew the screw, then pull upwards the protective ring to be out from the motor base gently.
Note: Operators are strongly advised to install protective rings before flight. It can protect the safety of the drone propellers and the motors.
Drone Battery
Installation:
Push the battery correctly into the drone battery compartment. Make sure that
you hear a clicking sound indicating the battery is firmly installed.
Removal:
Press the lock button on the battery and pull it back to remove the battery
from the compartment.
The battery should be installed firmly, failure to do it may affect the flight safety of your drone.
Propellers
Installation:
As shown above, connect each propeller to its corresponding motor shaft,
either position “A/B”, then lock the propeller to the motor shaft.
- Removal: Use a screwdriver (provided) to remove the propellers in counter-clockwise.
- Attention: Pay attention to the “A” or “B” printed on each propeller. The drone will not fly unless the correct propeller is installed on the correct motor shaft.
Phone Holder
Pull the back cover out and install and remove the phone holder as shown above.
Transmitter Battery
Always use alkaline batteries, and never mix old and new batteries.
- Unscrew the battery cover, press and slide the battery cover out, and insert 4 x AA batteries(not included), make sure to insert them following the correct polarity as shown.
- Re-attach the battery cover.
CHARGING
Drone Battery
- Remove the battery from the drone and insert the charging wire into the battery charging slot.
- Connect the USB charging cable with a power bank or a USB adapter (5V/2.0A) for charging.
- When the battery is charging, the USB indicator will glow red.
- The red light will go out when the battery is fully charged.
WARNING
Before charging, please read the instructions in the “2.3 Use of Battery”
section of the “Safety Guidelines” carefully!
OPERATION GUIDE
Pairing
- Short press the power button to turn on the transmitter and it will beep once and its indicator light flashes.
- Long press the power button to turn on the drone, and the indicator lights on the drone will flash.
- Place the drone on a flat and level surface with the head forward and the tail facing towards the operator.
- Slowly push the left joystick of the transmitter up to the top and the transmitter will beep once and then pull down to the bottom and the transmitter will beep once again. Pairing is completed once the drone lights and transmitter lights stop flashing.
Download APP
For iPhone, please scan the QR Code (Apple Software) on the packaging or
below, or type WOWITOYS, to go to the App store to download the software; For
Android mobile phones, please scan the QR Code (Android Software) on the
packaging or below, or type WOWITOYS, to go to the Android Eloquent
Market/Google play to download the software.
Connect to the APP
Connect your smartphone to the WiFi network created by the drone.
To check the drone’s status in the ‘WOWITOYS” APP.
- Open your phone’s Wi-Fi settings and click Wi-Fi to search for the Wi-Fi of the drone.
- Select the Wi-Fi network: EC10o **.
- Wait for a couple of seconds for your phone to connect to the drone’s Wi-Fi. (4). Open the ‘WOWITOYS” application.
- Choose the corresponding drone and click the ” GO ” button to enter the operation interface of the APP.
WARNING
If app does not display images after connecting to the drone’s WIFI, please
tum off the local (3G/4G/5G) network of the smartphone firstly.
Calibrating the Gyro
After pairing, pull left joystick to the lowest left corner and right joystick
to the lowest right corner at the same time. This will reset the drone to its
original factory settings and will be ready to fly again.
Taking-Off/ Landing Method
- Method 1: Short press the one key take-off/land button” “, the drone will automatically take off and hover at an altitude about 1.2 meter. Short press the one key take-off/land button “ ” again, the drone will land slowly until landing.
- Method 2: Push the left joystick up until the propellers of drone rotate without taking off and then push up the left joystick again to take off. Pull the left joystick down until landing.
FUNCTION DETAILS
Taking Photos/ Video Recording
- Taking Photo: Press once to take a picture.
- Video Recording: Press once to start recording video, press again to stop recording.
Emergency Stop
Long press the emergency stop button on the transmitter, the motors will stop
rotating immediately.
WARNING
Only stop motors mid-flight in an emergency situation, doing so to reduce
the risk of damage or injury.
Trimming
If the drone is away in an unprompted direction, use the trim buttons to
correct the flight:
- Forward Trim
- Backward Trim
- LeftTrim
- Right Trim
Headless Mode
- To activate headless mode, short press “headless” button, the indicator lights on drone will flash, and the drone will fly in the desired selected direction, regardless of the direction the drone is facing.
- Press the headless button again to exist headless mode.
Speed Switch
Press the speed switch button to switch high or low speed mode freely.
Auto Return:
Long press the auto return button, the drone will automatically return in the direction of the tail before takeoff. (Most of all, operator must keep in mind the drone orientation before the drone takes off, otherwise the return direction of the drone will deviate.)
360º Flips
Perfomn 360° fiips by pressing the “fiip” button and immediately operate
the right joystick in the desired direction.
APP OPERATION INSTRUCTION
Emergency lock function
When you find the drone is very near to the people or obstacles during flying,
you could press the button to cut off the signal then to stop drone’s flying
immediately, to avoid crashes to the people or obstacles. You could turn on
the drone to enjoy the flying again as usual.
Customer Service:
MADE IN CHINA.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>