Hebei Fanwo Imp Exp MT5001 Remote Control User Manual
- June 8, 2024
- Hebei Fanwo Imp Exp
Table of Contents
Hebei Fanwo Imp Exp MT5001 Remote Control
FCC Remote Control Manual
- Supply Voltage—DC 3.0V , Battery 2*1.5V AAA (not included)
- Frequency 2.407GHz-2.473GHz (Peak output power: 5dBm)
- Instructions
OVERVIEW
INSTALLATION
- First time use need to match code, this product has memory function Replace battery is unnecessary match code
- Hold down “ ” &” ” keys for 3 seconds start match code, The first LED flicker
- Turn on the car body power now, The first LED lit up, Match code Success
- Remoter 10 seconds not run will be on standby,Press any key wake up “ “Forward,” ” Back,” ” Left,” ” Right,” s “Speed,” P” Brake.
- Keys caption
Press “S ” key set up speed, 1 led lit up is low speed, 2 leds lit up is medium speed,3 leds lit up is high speed, Back a car is only low speed P key hold the brake, All LED flicker
The remote controller only can be used with adult’s guidance
FCC STATMENT
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>