Bear JSQ-C10C1 Mini Food Processors and Choppers Instruction Manual

Bear JSQ-C10C1 Mini Food Processors and Choppers

Product Information

Specifications

• Product: Bear Humidifier
• Intended Use: Household or related scenarios
• Appearance: Beautiful and fashion design
• Features: Strict boil dry protection, top water filling design, easy clean, convenient use, simple functions, and strong safety protection

Warning: to avoid any harms caused by misuse of this product, please read this instruction manual carefully before using the appliance and use it strictly following the usage specified in the manual!

Product Introduction **

**

Thanks for using Bear humidifier! The Bear Humidifier series are independently researched and developed by our company. With a beautiful and fashionable appearance, strict boil dry protection, and top water filling design, our humidifiers are made for easy cleaning, convenient use, simple functions, and strong safety protection.

Machine and Parts Diagram

Note:
The product picture is for reference only, please take physical object as the standard.

Function Description

• Tips: For noise-sensitive users, do not place this appliance near your ears while sleeping. Please set it at a place 1 meter away from your body.
• When the machine runs out of water, it will stop working and no mists will be generated. The indicator will show red. You can add water into the water tank to resume the current working status.

Usage Instructions

Add Water

1. Take off the lid.
2. Inject clean tap water or purified water with a temperature between 6 ~ 40 degrees Celsius into the water tank through a container.
3. Install the lid component back on top of the water tank.

Attention:

• Do not inject water into the air outlet.
• The added water cannot exceed the highest water level indicated on the tank.
• Pour out water from the water channel; do not pour water from the direction of the air outlet.
• Make sure the power cord is unplugged when injecting water into the machine.
• Make sure the power cord is unplugged when moving the machine.

Install Cap and Floater

1. Put the floater (both positive and negative sides) into the magnetic pillar.
2. Set the cap correctly (tighten it).

Install Mist Tube

1. Install the energy-gathering (either side) ring into the mist tube.
2. Buckle up the mist tube cap onto the tube.
3. Install mist tube components into the machine properly.

Clean & Maintenance

Clean Water Tank and Atomizing Sheet
Add some cleanser or mix white vinegar with water to clean the water tank, then wipe it dry with a soft cloth;
Use soft cloth or swab to clean the atomizing sheet.

Two, clean mist tube components
Clean inside of the mist tube with clear water, then wipe it dry with a soft cloth.

Attention:

1. Please make sure the power cord is unplugged before cleaning.
2. When wiping stain on power cord, please use a dry and soft cloth.
3. Water tank, incrustation and scale in the water channel as well as other debris must be cleaned regularly, suggested as cleaning it every 1 – 2 weeks.
4. To avoid bacteria, please change the water in water tank and channel regularly.
5. If you leave the machine unused for a long time, please clean it, put it into packaging box once dried out, and place at a dry place for safe storage.

Attention:

• Make sure the power cord is unplugged before cleaning.
• When wiping stains on the power cord, please use a dry and soft cloth.
• Water tank, incrustation, scale in the water channel, and other debris must be cleaned regularly, preferably every 1 – 2 weeks.
• To avoid bacteria, please change the water in the water tank and channel regularly.
• If you leave the machine unused for a long time, please clean it, put it into the packaging box once dried out, and place it in a dry place for safe storage.

FAQ

Q: What should I do if the machine is not functioning properly even after following the instructions?
A: If the phenomenon still exists after checking with the above instructions, please contact our customer support for assistance.

properly
Water in the tank has been used out| Inject water into water tank
Unusual odor| Debris in water channel or water tank| Clean water channel and water tank, change clear water
There’s water in water tank but machine shows lack of water| Floater has dropped down as the water level in water tank is quite low, it is normal that machine shows as lack of water;| Inject water into water tank
There’s water in water tank but machine stopped working after a period of time| Machine is not placed at a flat ground, which caused low water level of water channel, and the machine has stopped working from automatic protection| Place the machine at a flat and solid ground
Lack of steam| Water level is lower than 40mm in the water tank, machine produces less mist accordingly;| Inject clear water into the water tank
Water level nears to the highest level, machine produces less mist when at a high water level| Reduce water for 30 – 40cm from the maximum water level, the machine will produce more mist
Machine is in low energy mode of atomization| Switch to a higher energy mode of atomization
Impounded water near humidifier| Use of humidifier caused low air flow and increased humidity in the environment nearing to machine, and the steam keeps increasing and finally forms into impounded water| Switch to a lower energy mode of atomization; place the machine at a place(e.g. near the air conditioner, air fan) with faster air flow so as to achieve even spread of the steam.
Humidifier doesn’t produce mist| Water in the water tank exceeds maximum level| Pour out water till below the maximum water level

Note:
if phenomenon still exists after checking with above instruction, please contact our repair center or distributor, any one not the specialist of our company are forbidden to disassemble this machine.

Adjustable knob control

standby mode, the light indicator is off; rotate the knob clockwise(maxi- mum angle as 270°) till the sound Tick, machine opened with indicator shown as green; mist volume increases along with the increasing angle till maximum volume with maximum angle as 270°

Tips:

• For noise-sensitive users, do not place this appliance at the position near ears for your sleep, please set it at a place 1 meter away from your body
• When the machine runs out of water, it will stop working and no mists will be generated with indicator shown red; you can add water into water tank to resume current working status

Diagram illustration

Oe, Install cap and floater

1. Put the floater(both positive and negative sides) into magnetic pillar
2. set the cap correctly(set tight);

Two, Install mist tube

1. Install the energy-gathering(either side) ring into mist tube;
2. Buckle up the mist tube cap onto the tube;
3. Install mist tube components into the machine properly

Usage

One, add water:
Take the lid off, inject water into water tank through container, then install the lid component back to top

Attention:

1. Please add clean tap water or purified water with temperature between 6℃ ~ 40℃.
2. Do not inject water into air outlet.
3. Added water cannot exceed highest water level.
4. Please pour out water from the water channel, do not pour water from the direction of air outlet;
5. Please make sure the power cord is unplugged when injecting water into the machine.
6. Please make sure the power cord is unplugged when moving the machine.

Precautions

Please read these instructions carefully before using this product, and save this manual for future use;
Ignorance to any instruction or any operation error may lead to a major accident or other injuries, so please strictly follow the instructions below:

1. This is a 220V – 240V ~ 50Hz – 60Hz appliance, please check your voltage standard before using it, otherwise there could be dangers including electric shocks and fire disasters.
2. Please do not damage, modify, forcefully bend, pull, pinch or bundle the power cord, also, please do not put heavy objects upon the cord to avoid any possible danger
3. Please unplug the humidifier when you clean it.
4. Please make sure the humidifier is well placed with good power connection, extension cords cannot be used.
5. When pull the plug, please hold plug. Do not pull the cord forcefully otherwise there could be risks of electric shocks, short circuits, etc.
6. When this product is working, distance between electric outlet and charged object must be kept, with the plug unreachable and away from inflammables and explosives, otherwise there could be risks of electric shocks, fire disasters, etc.
7. Humidifier should be placed at the flat and solid ground to avoid water overflow or damages caused by inclination and fall.
8. Do not use hard objects to touch or strike atomizing sheet, clean with swabs or soft brushes.
9. Do not use a cloth with chemical solvent, gasoline, kerosene, polishing powder to wipe the surface.
10. Do not use this product near the bathtub, shower nozzle and swimming pool in case fire disasters caused by electric shock.
11. Do not immense objects of this product.
12. This appliance is not intended for the use of physically or sensory disabled, mentally ill people or persons without product experiences and knowledge alone. To ensure safety, please let those people use this product under supervision and guidance of person who knows well about it.
13. Please watch your children carefully and ensure that they do not play with this appliance.
14. Do not electrify this product when injecting waters and cleaning the humidifier, please do not turn it on when the base is empty.
15. Please do not pull the cord by wet hands. Do not touch power cord or the plug when it thunders so as to avoid electric shocks.
16. When this product is damaged or unable to work normally, please shut off the power and pull out the plug immediately. This product can be assembled or disassembled by professional maintenance staffs only, do not it by yourself otherwise there could be dangers as fire disasters, electric leaks.
17. The product is intended for household or related scenarios use only.
18. To avoid risks, damaged power cords must be changed and replaced by professional staffs from manufacturer, maintenance department or related departments.
19. Please turn off this product when the water in water tank has been used out, you can turn it on again once completed water injection to graduation line (fill up if there’s no graduation line). Full tank represents rated volume
20. This product should be cleaned weekly, if it is not used for a long time, please drain out the water. To avoid bacteria, please change the water in water tank and channel regularly
21. Do not add additives into water tank or water channel: e.g. essential oil, perfume. Any uncomfortable symptoms or sicks caused by above should be at your own risk.
22. For people who are rheumatism patients, asthmatics or with allergic constitution, please consult the doctor for the usage of this appliance based on personal health condition and strictly follow the doctor’s advice

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>