Amico 5CCT 5 In 1 Slim Panel LED Recessed Downlight Installation Guide

5CCT 5 In 1 Slim Panel LED Recessed Downlight

5 In 1 Slim Panel
LED Recessed Downlight

IC Rated Junction Box

Easy Intallation

1. Install the drywall directly over the rough-in paper.
   NOTE: It is suggested to use your own method in locating the center of the aperture hole,

2. Select your desired method of cutting either using a hand saw or hole saw to cut an opening in the ceiling by using the provided template.

3. After seiecting the desired method of cutting, cut out a 6.33″ diameter hole in the mounting surface.
   CAUTION: Do NOT cut a hole that exceeds or that is larger than the paper opening.

4. Make sure all POWER IS TURNED OFF at the electrical source to the location in which you  are mounting the luminaire,

5. Remove the cover of the provided J-BOX and insert wire nuts to make connections with power supply. Insert splices in J-BOX before concealing the cover.

6. Connect the J-BOX to the tight module.

7. Turn on the power and slide the CCT Selection Switch to test the light.

BEFORE INSTALLATION:

On the back of the J-BOX, slide the CCT Selection Switch and choose from five available color temperatures: 2,700K; 3,000K; 3,500K; 4,000K; and 5,000K

• Test results from each CCT Selection to determine which brightness level suits your room best.

• The light will use the preferred setting whenever you turn on the switch.

• Turn off the light switch and continue with the installation.

  8. Place the J-BOX through the cut-out hole and mount according to your local electrical code compliance.
  9. Rotate and hold both spring clips upward to allow passage through the cut-out in the ceiling.
     Continue to press the light module through the cut-out hole until it is securely fixed and flushed with the ceiling.

WARNING
— RISK OF FIRE OR ELECTRIC SHOCK CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH Cl CUIT CONDUCTOR.
— RISK OF FIRE MIN 90°C SUPPLY CONDUCTORS.
— DO NOT make or alter any open holes in an enclosure of wiring or electrical components  during kit installation.
— To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
CAUTION
— Edges may be sharp. Please wear gloves while handing.
— Product designed for dimming with many 120V TRIAC/ELV phase cut contro! dimmers.
— Product can be installed directly into a ceiling without requiring separate J—box or recessed housing.
— Connect fixture to a 120V 60Hz power source, any other connection voids the warranty.

SPECIFICATIONS

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>