Virutex EB140PLC Hot Melt Edge Bander Instruction Manual

June 14, 2024
Virutex

Virutex EB140PLC Hot Melt Edge Bander

Product Information

Specifications:

  • Model: EB140PLC
  • Pre-Milling: Yes
  • Working Width: 140 mm (approx.)
  • Working Length: 600 mm (approx.)
  • Working Thickness: 19 mm
  • Number of Included Samples: 1

Product Usage Instructions

  1. Section 1: Preparing for First Use
    The device is prepared for initial use straight out of the factory. No additional setup is required.

  2. Section 2: Installation

  3. Ensure that the device is placed on a stable and level surface.

  4. Connect the device to a suitable power source.

  5. Section 3: Initial Setup
    Attach the included 1-meter tape to the device for reference.

  6. Section 4: Panel Preparation
    Place the panel to be processed on the working area.

  7. Section 5: Operation

  8. Set the device to “ON” and allow it to heat up.

  9. Press the “ON” button to start the operation.

  10. Wait for the device to finish the gluing process.

  11. Section 6: Board Rectification
    Perform any necessary adjustments or rectification of the processed panel.

  12. Section 7: End Cutting
    Use the end cutting function to trim the panel to the desired length.

  13. Section 8: Trimming
    Use the trimming function to give the panel its final shape.

  14. Section 9: Scraper
    Utilize the scraper function to achieve a smooth and even surface.

Frequently Asked Questions (FAQ)

  • Q: What is the working width of the device?
    A: The working width of the device is approximately 140 mm.

  • Q: Does the device come with any included samples?
    A: Yes, the device includes 1 meter of tape for reference.

  • Q: How do I start the device?
    A: Press the “ON” button to switch on the device and allow it to heat up.

  • Q: What should I do if the processed panel requires further adjustments?
    A: Perform any necessary rectification or adjustments using the appropriate functions of the device.

Dimension

1 m. of tape included

Installation

PLACE THE TAPE

  • Press cylinder and open the blade
  • Pull lever to open the roller (keep open on steps 9-15)
  • Put tape into guide and slide
  • Check tape exit
  • Check tape slides smoothly
  • Move back tape 5 cm from blade
  • Pull the cylinder and close blade
  • Put the tape against blade
  • Put the tape against blade
ADJUSTMENT OF THE PRE-MILLING UNIT

(Machine is factory-set to edge thickness: 2 mm. For different thicknesses, perform adjustment sequence.

  • Loose the crank handles of the base of pre-milling unit.
  • Adjustment of the pre-milling unit: Adjust the thickness of the digital counter with knob.
  • Lock handles.
  • Place the guide supplement if necessary according to thickness of the edge.
  • Measure panel thickness.
  • Adjust panel thickness on the digital counter.
  • Adjust panel thickness in feeder closure flange.

How To Use

SWITCH ON AND GLUE HEATING

Access to all technical information

Virutex, S.A.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals