Brigii MX20 Crevice Vacuum Instruction Manual
- June 14, 2024
- brigii
Table of Contents
Brigii MX20 Crevice Vacuum
Instruction
Notice
- Do not use the vacuum while charging. Please disconnect the charging cable before using it!
- Please fully charged before first use!
OPERATION AND DISPLAY STATUS
| Operation | Vacuum Status | Indicator Status |
|---|---|---|
| **** Press the power button |
- Working properly
- **** Low power
|
- Solid white light
- **** Red light blinking and then goes out
Press the power button| Stop working| The indicator went out
**** Charging|
- Charging
- Fully charged
|
- Red light blinking
- Solid White light
TROUBLESHOOTING
| Operation | Reasons | Solutions |
|---|---|---|
| Won’t charge | Not connecting the power supply correctly | Please check the |
power supply and charger block and connect them correctly
- Overheating of the vacuum or surrounding
- Low-temperature of the vacuum or surrounding
|
- Please stop charging, let it sit for 15 minutes and charge it again after reaching the room temperature
- (Please use, store and charge it within an ambient temperature of 0°C{32° F)-40°C(l 04° F))
Won’t turn on| Out of power| Please charge before use
Cable connected| The vacuum cannot be turned when the cable is connected to
the power supply
Won 1 t turn on| Blockage caused thermal cut-out| Please follow
the instructions to clean the dust cup and filter before use
---|---|---
- Overheating of the vacuum or surrounding
- Low-temperature of the vacuum or surrounding
|
- Please stop charging, let it sit for 15 minutes and charge it again after reaching the room temperature ( Pl ease use, store and
- charge it within an ambient temperature of 0°C(32°F)-40°C(104°F))
Abnormal noise when using| Incorrect filters were installed and foreign
objects sucked| Turn off the power, try to take out the objects and install
the filter correctly
Suction decreased| The dust cup is full Air inlet or filter be clogged| Clean
the air inlet and dust cup on time according to the instructions or change the
filter on time
**** Low power| Please fully charge before use
Please contact Brig ii customer support team, if your problem still cannot be solved.
- Official website: www.brigii.com
- Email : support@brigii.com
CLEANING AND MAINTENANCE
The suction power and battery life may decrease if the A filter is clogged, please clean the filter in time or change aA the filter. A good rule of thumb is to change your high performance filter every 3 months.
- Do not wash the motor housing.
-
Rotate the dust cup in the direction of the arrow to open it and remove the filter assembly. Then disassemble the HEPA filter.
-
Wash the filters and dust cup, air-dry them completely and reassemble the filters.
More languages
www.Brigii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>