AQUACREST AP2-C401-S Water Filter Instruction Manual
- June 14, 2024
- AQUACREST
Table of Contents
AQUACREST AP2-C401-S Water Filter
Information
A replacement for the following water filters:
3M® filters
- AP2-C401-SG, AP2-C401-S
Lincat® filters
- FC02, EB3F, EB4F, EB6F
- Filter life: up to 6 months or 1,057 gallons, whichever comes first will vary based on water condition.
Installation Instructions
- Twist the base of the filter 90 degrees to the left and carefully lower the filter cartridge out of the appliance. It will contain a small amount of water.
- Remove the black cap and place on the new filter.
- Insert the filter fully into its recess and twist to the right to lock in place.
- Press and hold the “Fn(Function)” button for 5 seconds to reset the filter life monitor.
- Drain off approximately 5 litres of water to remove any loose carbon particles from the filter.
Caution: This filter should not be used with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Operating specifications
- Minimum operating temperature …………………………………………………………………………………………………………………………………………………… 0.6°C/33°F
- Maximum operating temperature ………………………………………………………………………………………………………………………………………………… 38°C/100°F
- Min. working pressure …………………………………………………………………………………………………………………………………………………………………..140 kPa/20 psi
- Max. working pressure ………………………………………………………………………………………………………………………………………………………………. 689 kPa/100 psi
- Rated capacity ……………………………………………………………………………………………………………………………………………………………..4,000 litres/1,057 gallons
- Flow rate ………………………………………………………………………………………………………………………………………………………………………………………..1.9 lpm/0.5 gpm
Maintenance
Storage and maintenance
- Replace your filter every 6 months or 1,057 gallons to achieve optimal performance and prevent bacteria and fungus growth in your filter and supply lines.
- Keep your unused filters in a cool, dark, and dry place until you need them.
Frequently asked questions
- Q: Why is it difficult to twist the new filter into the filter housing?
- A: Pressure inside may cause the expansion of connector, increasing the installation difficulty. Therefore, it is recommended you push the new filter in with a little bit of force, but not too hard. Then turn it clockwise.
- Q: Must the filter be changed every 6 months?
- A: Yes. You must replace the filter every 6 months or sooner if water flow is reduced or if there is heavy sediment/rust sediment. Filters left in longer will fatigue, degrading the filter performance.
- Q: Do I need to flush the filter before using?
- A: Yes. It is highly recommended you flush the filter before using. Water filters are made from advanced coconut carbon block, so there are some carbon fines in the filter. You need to flush firstly to remove those carbon fines to get clean water.
Warning
- To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance with the manufacturer’s specifications and instructions. This filter unit must be replaced every 1,057 gallons or 6 months.
- Failure to follow instructions and operating specifications will void your warranty. Further, manufacturer assumes no responsibility or liability for damages arising out of misuse of the product.
- Lincat® is a registered trademark of Lincat Group plc.
- Lincat® is used for reference purposes only.
The service life mentioned above is subject to chlorine reduction.
Actual result varies according to the local water quality.
Manufacturer Technical Support
- E-mail: service@water-filter.com
- Tel: 1-888-352-3558 (U.S.)
- Qingdao Ecopure Filter Co., Ltd.
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>