Yiwu Duke 040 Smart Bike Taillights Remote Control Turn User Manual

Yiwu Duke 040 Smart Bike Taillights Remote Control Turn

Function Description

Remote control: a total of 4 buttons, each button is equipped with an indicator.

1. Left turn light: press the left turn key, the indicator light of the left turn key will be on, and the left turn light of the tail light will flash at the same time, and then press to turn off the left turn light.
2. Right turn light: press the right turn key, the indicator light of the right turn key will be on, and the right turn light of the tail light will flash at the same time, and then press to turn off the right turn light.
3. Warning lights:
4. Press the on key, the key indicator light will be on, and the red warning light in the middle of tail light will flash. Press  the on key again, and the red warning light will flash slowly. Press the on key for the third time, and the red warning light will turn off.
5. Press  the warning key, the key indicator light is on, and the red warning light is always on. Press the warning key again, and the red warning light is off.

High quality remote control LED direction warning light is used for bicycles, baby carriages, jogging, walking. road emergency and camping at night. Its direction flashing indication and reminding function greatly enhances the safety factor of night travel

Operation method of tail lamp

1. When charging, please remove the tail lamp, open the protective cover of the rubber charging port on the back of the tail lamp, insert the micro plug to charge the USB charging cable, the red indicator light is charging, and the full power turns green.
2. The lamp and remote control are matched at the factory and can be used after installation.
3. The tail lamp and controller are combined with the corresponding accessories, and then respectively installed in the appropriate position of the vehicle.

Product features:

1. Large visual range.
2. Easy to install.
3. It is equipped with 500mah rechargeable battery, charging time is 2 hours, and it can be used for 4-5 hours after full charge.
4. The surface waterproof effect reaches ipx2 to ensure daily use.
5. High quality led to ensure the warning effect.

Matters needing attention:

1. Don’t disassemble and refit without permission.
2. This product is only rain proof, do not soak the product in water.
3. After use, please turn off the tail light switch button to avoid battery power loss.
4. Pay attention to the battery inside the tail lamp, and do not replace it by yourself.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuan t to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interferenc e to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different f rom that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>