Enerlites 61100 TR3USB-CU Series Triple USB Charger 58A w 15A Single TR Outlet Instruction Manual
- June 14, 2024
- ENERLITES
Table of Contents
Enerlites 61100 TR3USB-CU Series Triple USB Charger 58A w 15A Single TR
Outlet
Product Information
The product is a 15/20A Tamper Resistant Receptacle with Three Ultra High Speed USB Charger Ports. It is designed to be installed in accordance with the National Electric Code and local regulations. The installation should be performed by a qualified electrician. The receptacle features a neutral white wire, a ground green wire, and two hot black wires. It is important to turn off the circuit breaker or fuse(s) and ensure that the power is off before wiring the device. The USB receptacle is not compatible with outlets where the top and bottom outlets are controlled by separate circuit breakers. The device is compatible with a wide range of electronic devices.
Product Usage Instructions
- Before installation, ensure that the POWER is turned OFF at the circuit breaker.
- Read and understand the installation instructions provided.
- It is recommended to have a qualified electrician perform the installation.
- Make sure to turn off the circuit breaker or fuse(s) and ensure that the power is off before wiring the device.
- Use copper wire only for wiring.
- If replacing the USB module, use a flat screwdriver to pry-off the interchangeable module.
- Ensure compatibility of the device with your electronic devices.
For any warranty information or further assistance, please visit www.enerlites.com.
SPECIFICATIONS
- Receptacle Rating …………………………………………………………. 15/20 Amp, 125VAC
- USB Rating …………………………………….Three USB ports with total 5.8 Amp, 5VDC
- Wire Terminals ……………………………………………………………………….#14–#12 AWG
- Operating Temperature ……………………………………………. -4 to 140°F (-20 to 60°C)
- USB Compatibility ……………….. USB 1.1/2.0/3.0 devices, including Apple products
- Receptacle Dimension …………………………………………………..3-3/4”×2-1/4”×3-3/16”
DESCRIPTION
61150/61200-TR3USB-CU is the Industry’s first 5.8A, 5VDC triple USB charger with a single 15/20A tamper resistant receptacle. Our High Speed USB ports deliver the most advanced charging technology and optimize current by using a smart chip to reduce charging time to devices. Our High Speed USB chargers give you the ability to charge virtually any device without the use of bulky adapters that can be lost or misplaced, while continuing to power traditional appliances, e.g. lamp or television with the same receptacle.
FEATURES
- Industry’s first Triple USB High Speed charger at 5.8 Amp, 5VDC.
- Charges most USB compatible devices directly without an adapter.
- 2011 NEC Code compliant Tamper-Resistant Shutters.
- Replaces a standard duplex receptacle.
- Choose between 15A or 20A modules. Comes with ONE Interchangeable USB module.
- Wire terminals are designed for easy installation from the back or side.
WARNING
- Turn the POWER OFF at the circuit breaker before installing the receptacle.
- Read and understand these instructions before installing. This device is intended for installation in accordance with the National Electric Code and local regulations. It is recommended that a qualified electrician performs this installation. Make sure to turn off the circuit breaker or fuse(s) and make sure power is off before wiring the device.
- Use copper wire only.
- This USB receptacle CANNOT be used if the outlet you are replacing has the top and bottom outlets controlled by separate circuit breakers.
WIRING DIRECTIONS
There are two ways to wire the receptacle:
- Loop wire around terminal screws and firmly tighten terminal screw.
- Insert wire(s) through terminal holes in the back, then tighten terminal screws. Use this method when attaching 2 wires to same terminal.
- Connect HOT wire to the HOT terminal (brass screw).
- Connect NEUTRAL wire to the NEUTRAL terminal (silver screw).
- Connect GREEN or BARE wire to the GROUND terminal (green screw).
COMPATIBILITY
This USB Charger/Tamper-Resistant Receptacle is compatible with a wide range
of electronic devices including, but not limited to, the
following:
- iPad® Pro
- iPad® Air
- iPad® Mini
- iPod®
- iPhone ® 6/ 6 Plus
- Tablets
- Mobile Phones
- Bluethooth ™ Headsets
- Digital Cameras
- HTC One X9™
- HTC One S9™
- Samsung Galaxy S4™
- Samsung Galaxy Note 3™
- Samsung Galaxy J7™
- Galaxy Tab™
- Other Smart Phones and USB
- Compatible products
WARRANTY INFORMATION
This device is warranted to be free of material and workmanship defects for 2 years from the date of purchase. Original receipt or proof of purchase from an authorized retailer must be presented upon warranty claim. ALL claims must be verified and approved by Enerlites, Inc. Warranties from other Enerlites products may vary. This warranty is nontransferable and does not cover normal wear and tear or any malfunction, failure, or defect resulting from misuse, abuse, neglect, alteration, modification, or improper installation. To the fullest extent permitted by the applicable state law, Enerlites shall not be liable to the purchaser or end user customer of Enerlites products for direct, indirect, incidental, or consequential damages even if Enerlites has been advised of the possibility of such damages. Enerlites’ total liability under this or any other warranty, express or implied, is limited to repair, replacement or refund. Repair, replacement or refund are the sole and exclusive remedies for breach of warranty or any other legal theory.
© 2019 Enerlites Inc.
CA, U.S.A.
WWW.ENERLITES.COM
0212160065-04
REV 20230803
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>