Grizzly Industrial T32798 Axe Sharpening Jig Instruction Manual
- June 4, 2024
- Grizzly Industrial
Table of Contents
Grizzly Industrial T32798 Axe Sharpening Jig
Introduction
The Model T32798 Axe Sharpening Jig is a fixture for sharpening axes with blades up to 61⁄2″ long on the Model T32720 10″ Wet Grinder.
|
To reduce your risk of serious injury, read this entire manual BEFORE using
machine.
---|---
Eye and face injuries and respiratory problems can occur while operating
this tool. Wear personal protective equipment to reduce your risk from these
hazards.
| |
|
Keep hair, clothing, and jewelry away from moving parts at all times.
Entanglement can result in death, amputation, or severe crushing injuries!.
---|---
Using Jig
-
DISCONNECT GRINDER FROM POWER!
-
Install tool rest in vertical position over grinding wheel so grinding will occur against wheel rotation
-
Slide jig onto tool rest and insert axe into jig, as shown in Figure 1.
-
Adjust tool rest closer to or further from grinding wheel until desired grinding angle is achieved.
-
Tilt axe away from grinding wheel, connect grinder to power, and turn machine ON.
-
Use firm grip to return axe to surface of grinding wheel to sharpen axe against wheel rotation. Rock axe back and forth while grinding to sharpen entire cutting edge of axe (see Figure 1).
COPYRIGHT © JUNE, 2021 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE
WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
(FOR MODELS MFD. SINCE 07/21) #CS21978 PRINTED IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>