EXECUTIVE C-2892-1A Ergonomic Home Office Desk Chair Instruction Manual
- June 14, 2024
- EXECUTIVE
Table of Contents
EXECUTIVE C-2892-1A Ergonomic Home Office Desk Chair Instruction Manual
PRODUCT OWERVEV
To deodorize the leather please leave the chair in shady outside for 1-2 day
For longer use
Re-tighten bolts every 6 months by using the enclosed Allen-key. *Using an electric drill may damage the chair. Please re-tighten bolts manually.
Safety Information
-
Sit in the center of the chair, let your back fit the backrest
-
Do not sit at the front edge of the chair
-
Do not stand on the chair
-
Do not use the chair with more than one person
-
Do not push the chair around when a person is sitting in it
-
Do not push down the backrest when a person is reclining
-
Do not place all your weight on only the backrest
Package List
-
*1 Backrest
-
*1 Seat Cushion
-
1L 1R Armrests
-
*1 Mechanism
-
*1 Gas Lift
-
*1 Base
-
*5 Legs
-
*5 Casters
-
*4 Bolts
-
*8 Bolts
-
*10 Bolts
-
*8 Caps
-
*1 Wrench
Assembly Instruction
-
Turn the Base (6) upside down. Install Legs (7)5 to the Base (6) with Bolts (11)10.
-
Press Casters (8)5 into the holes at the end of Legs (7)5.
-
Turn the Base back, and insert Gas Lift (5) into the center hole of the Base
-
Attach Mechanism (4) to the Seat Cushion (2) with Bolts (9)*4.
NOTE:
Make sure the “FRONT” direction of Mechanism (4) and Seat Cushion (2) are the same. -
Align the center hole of the Seat Mechanism with Gas Lift (5) and press the Seat Cushion down until it is fully secured. Attach Armrests (3)1L1R to both sides of the Seat Cushion (2) with Bolts (10)*4.
NOTE:
Bolts are only tightened 30%. -
Tilt the Backrest (1) down. Attach Armrests (3)1L1R to the screw holes on the lower side of the Backrest (1) with Bolts (10)*2.
NOTE:
Bolts are only tightened 30%. -
Rotate the Backrest (1) up. Attach Armrests (3)1L1R to the screw holes on the upper side of the Backrest (1) with Bolts (10)*2
NOTE:
Bolts are only tightened 30%. -
Adjust the balance on each side of the Chair, and 100% tighten the Bolts (10)8 on both sides of the Armrests. Then Press Caps (12)8 into screw holes of each side.
Instructions For Use
CAUTION:
- Before using the chair, check to ensure that all bolts are fully tightened.
- Lubricate all parts and tighten all bolts every 6 months or whenever needed.