REDRAGON 2820 Gaming Mouse User Manual
- June 14, 2024
- REDRAGON
Table of Contents
REDRAGON 2820 Gaming Mouse
Dear user
Thank you for choosing our product. To protect your rights and for better customer service, we ask that you note our warranty rules.
- Within the guarantee period, the repair is guaranteed for failure due to electrical circuit problems. Other damages, such as disassembly, hard impacts, submersion into water, plugging into improper current or voltage, and damage caused by natural disasters such as fire, flood, or earthquake are not included.
- Consumable parts (such as a foot pad) and spare parts replacement are not Included In our warranty.
Button Instructions
- Left mouse button.
- Right mouse button,
- Scroll wheel (clicked as middle mouse button).
- Rapid fire button(Defaulted to three rapid clicks of the left mouse button).
- Side key, defaulted function: FORWARD key on the keyboard.
- Side key, defaulted function: BACKWARD key on the keyboard.
- DPI+ button (defaulted to speed up the cursor).
- DPI- button {defaulted to slow down the cursor).
- Light mode toggle key: The mouse switches between the 6 lighting modes for each click.
- User mode toggle key: The mouse switches between the 5 user modes with each click.
- Teflon foot pads: Large weaNesistant materials let the mouse move more smoothly.
Lighting Instructions
- User mode indicator light: Located below the Scroll Wheel key.
- Red —— User mode t
- Blue — User mode 2
- Green- –User mode 3
- Purple — User mode 4
- Yellow — User mode 5
- 5 colors indicator light:
- Red —— Gear 1 (1000 DPI)
- Blue —— Gear 2 (2000 DPI)
- Green— Gear 3 (4000 DPI)
- Purple – Gear 4 (8000 DPI)
- Yellow — Gear 5 (16000 DPI)
- Lighting: Breathing, Neon, Full lighted1Wave, Tail, Reaction1Flash, OFF.
Software Instructions
User can adjust the following settings through the software after downloading and installing it.
- Adjust the DPI of the mouse at the user1s discretion.
- Adjust the polling rate of the mouse at the user’s discretion. (range: 125-250-500- 1000HZ).
- Macros: Record up to 59 actions and trigger with one key.
- Continuous keystroke function: Set the number of clicks and delay time.
- Lighting: Adjust mouse lighting options.
- Customize mouse buttons.
- Set 5 different user modes.
FAQ
- If the mouse is not responding, please check whether the mouse Is plugged correctly in the corresponding computer’s USB port, or try another USB port.
- If the mouse is moving slowly, jumping or with delay, please try another surface. Dark, dirty, un-flat, bright surfaces may affect the performance of the mouse. Mouse pad is strongly recommended.
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user1s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful Interference In a residential Installation. This equipment generates uses and can radiate radio frequency energy and, if not Installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver Is connected.
- Consult the dealer or an experienced radionic technician for help
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions (1 )this device may not cause harmful
Interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device contains license-exempt transmitter(s}/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause Interference. (2) This device must accept any Interference,
Including Interference that may cause undesired operation of the device.
Please scan here to download user manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>