AKUMAKA C1pa9daXHQL Smart Watches for Women User Manual

AKUMAKA C1pa9daXHQL Smart Watches for Women

Product Introduction

Note : Before using the product for the first time, please charge it with the charging cable to switch it on.

Wearing
Please wear the device on your wrist horizontally, a finger’s width below your wrist bone. And also adjust the tension of the wrist band to a comfortable position.
Tip : Too loose band may affect the accuracy of data cotlected by the heart rate sensor.

Connection and Binding

1. Search and download “GloryFit App from Apple StOf’e or Google Play.

2. With your mobile phone, scan the QR code of the watch screen (Settings APP QR code) to install the “Glory Fit” APP. You can also scan the QR code below to download:

3. After installing the App, please open it and login. Click the “Device” page>> Click “Add a new device”» Select Smart Watch or scan the QR code on the watch screen to connect. “The Gloryfit App is only compatible with smartphones, not for tablets or PCs.
   Smart Phone System Requirements:

   • ios uo & higher
   • Android 9.0 & higher
     Note : After connecting the App, you need to turn on the mobile phone Bluetooth to synchronize the contacts, so that the contact names can be displayed on the watch. (the operation steps a re as follows)

Tips :

• In the process of pairing, please make sure the Bluetooth function of your smartphone is enabled.
• Allow the permissions when installing the App. If the watch can’t be found or connected during use, turn on theGPS function of your smartphone and permit the ” Location” request in the App. Then select Setting – Factory Default. Then try to connect the watch again.

If the watch still cannot be connected, exit and re-enter the APP to try again. The connection status of the watch is as shown in the figure below:

Operation

• Control Panel: Swipe down from top to bottom on the homepage of the watch dial.
• Message Notification: Swipe up from bottom to top on the homepage of the watch dial.
• Main Menu: Swipe the home page of the watch face towards the right side.
• Status display: Swipe the home page of the watch face towards the left side.
• Shortcut to switch the dial: Long press the homepage for 2-3 seconds until the watch vibrates once, and then swipe to left or right to select the dial.
• Return : Tap the power button to return to previous page.
• Power-On/Off: Press and hold the power button for 5 seconds. (Power-off: Press and hold the power button for3 seconds when the display is on, then select poser off)

Function Introduction

Note : When using the watch to play music or make/receive calls, the high power consumption will affect the battery life.

Charging

1. Put the watch onto the charging connector and make the charging contact piece on the back of the watch completely fit the metal contact on the charging connector. (The charging time should be more than 2 hours.)
2. Connect the charging cable to a standard charger purchased through a regular channel. The output voltage should be SV and the output current should be lA. If the watch cannot be switched on after it has been stored for a longtime, to use it again, wipe off any sweat or water residue on the charging contact piece of the charging cable.
   Note : (If the watch is not often used, please charge the watch once a month.)

Q &A

1. Failure to pair the watch with theGloryfit App on your smartphone.
2. Check whether your mobile phone system is Android 9.0 and later version, iOS 13.0 and later version.
3. Make sure your smartphone’ s Bluetooth is enabled and the watch is not connected to other smartphones.
4. It is recommended to exit the GloryFit APP and open it again, and re-enable the Bluetooth before connecting. Then try it again.
5. Failure to receive SMS / calls notifications.
6. Check if the Bluet.oath function on your mobile phone is enabled, and check whether the APP is keeping connected status with your watch. (Go to yoursmartphone Settings, find GloryFit app, and enable the Notifications, location and also allow it to keep running in the background)
7. Check whether you enable the the notification function in the smart.phone.
8. Check if your phone’s drop-down menu can show you the message notification when a message comes in. If not, please go to the system settings to enable the permission of the APP message to pop up in the smart phone.
9. If the issue still exists, please unbind the watch, exit the APP to reset the watch, disable the Bluetooth function of the mobile phone; then r e -pair the watch to your phone again.
10. Make sure the do-not-disturb function is not enabled in the app or the watch.

3. How to synchronize data?(re-connect)
4. Auto synchronization: The data will be synchronized automatically when the device is connected with the APP.
5. Manual synchronization: After the device is connected with the APP, you can pull down the data list in the home page and data interface for manual synchronization.
6. lf the data cannot be synchronized, please disable and enable the Bluetooth function of the phone again or restart the phone.
   ( Note: The Q&A in “Me” – “Common problem of the App may answer some of your questions about use.)

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part lS of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does rause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is connected .
• Consult the dealer or an experienced radio/TV technician for help.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the fol.lowing two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Safety instructions

• Please consult your doctor before starting a new exercise program. Despite its ability to track your heart rate, this smart watch is only intended to help people live healthier lives and should not in any case be used for any medical purpose.
• Remember to consult your doctor befre starting any exercise or diet program.
• Do not place the product and its accessories at ertreme temperatures, otherwise it may cause hazards such as product failure, fire or explosion.
• Protect the product from strong impacts or jolts, So as not to damage the product and its accessories, thus avoiding product failures.
• Do not disassemble or modify the product and its accessories O)’ yourself. Contact us for after-sales service when the product fails.

Old electrical appliances must not be disposed of together with the residual waste, but have to be disposed of separately. The disposal at the communal collecting point via private perrons is for free. If you experience discomfort or skin iritation when wearing your smart watch, then we recommend you try cleaning your device. Sometimes residue or foreign materials build up around your device and may aggravate your skin. It’s also possible that you are not wearing the watch correctly. We recommend making sure to clean and adjust your watch regularly for a more comfortable fit.

• If you experience skin iritation when wearing your watch, please refrain from wearing, and wait two to three days to see if your symptoms ease. If symptoms persist or worsen, please consult a physician.
• If you have eczema, allergies or asthma, you may be more likely to experience a skin irritation or allergy from a wearable device.
• Risk of explosion if the battery is replaced by an incorrect type, disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.
• Leaving a battery in an ertremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas.
• A battery subjected to ertremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>