COMFEE FD1435E-W Slimline Freestanding Dishwasher User Guide
- June 14, 2024
- comfee
Table of Contents
**COMFEE FD1435E-W Slimline Freestanding Dishwasher
**
TROUBLESHOOTING TIPS
Before Calling For Service
Reviewing the charts on the following pages may save you from calling for service.
| Problem | Possible Causes | What To Do |
|---|---|---|
| Dishwasher doesn’t start | Fuse blown, or the circuit break tripped. |
Power supply is not turned on.
Water pressure is low
Door of dishwasher not properly closed
| Replace fuse or reset circuit breaker. Remove any other appliances sharing the same circuit with the dishwasher.
Make sure the dishwasher is turned on and the door is closed securely. Make sure the power cord is properly plugged into the wall socket.
Check that the water supply is connected properly and the water is turned on.
Make sure to close the door properly and latch it.
Water not pumped form dishwashe| Twisted or trapped drain hose.| Check the
drain hose
| Filter clogged.| Check . the filter system
| Kitchen sink clogged| Check the kitchen sink to make sure it is draining
well. If the problem is the kitchen sink that is not draining , you may need a
plumber rather than a serviceman for dishwashers.
Foam in the tub| Wrong detergent| Use only the special dishwasher detergent to
avoid suds. If this occurs, open the dishwasher and let suds evaporate. Add 1
of cold water to the bottom of the dishwasher. Close the dishwasher door, then
select any cycle. Initially, the dishwasher will drain out the water. Open the
door after draining stage is complete and check if the suds have disappeared.
Repeat if necessary.
| Spilled . rinse aid| Always wipe up spills immediately.
Stained tub interior| Detergent with colorant may have been used.| Make sure
that the detergent has no colourant.
White film on inside surface| Hard water minerals| To clean the interior, use
the damp soft cloth with dishwasher detergent and wear rubber gloves. Never
use any other cleaner than dishwasher detergent otherwise, it may cause
foaming or suds.
There are rust stains on cutlery| The affected items are not corrosion
resistant| Avoid washing items that are not corrosion resistant in the
dishwasher.
| A program was not run after dishwasher salt was added. Traces of salt have
gotten into the wash cycle.| Always run a wash program without any crockery
after adding salt. Do not select the Turbo function (if present), after adding
dishwasher salt.
| The lid of the softer is loose.| Check the softener lid is secure.
Knocking noise in the dishwasher| A spray arm is knocking against an item in a
basket| Interrupt the program and rearrange the items which are obstructing
the spray arm.
Rattling noise in the dishwasher| Items of crockery are loose in the
dishwasher.| Interrupt the program and rearrange the items of crockery.
Knocking noise in the water pipes| This may be caused by on-site installation
or the cross-section of the piping.| This has no influence on the dishwasher
function. If in doubt, contact a qualified plumber.
The dishes are not clean| The dishes were not loaded correctly.| See PART Ⅱ
“Preparing And Loading Dishes”.
| The program was not powerful enough.| Select a more intensive program.
The dishes are not clean.| Not enough detergent was dispensed.| Use more
detergent, or change your detergent.
| Items are blocking the movement of the spray arms.| Rearrange the items so
that the spray can rotate freely.
| The filter combination is not clean or is not correctly fitted in the base
of wash cabinet. This may cause the spray arm jets to get blocked.| Clean
and/or fit the filter correctly. Clean the spray arm jets.
Cloudiness on glassware.| Combination of soft water and too much detergent.|
Use less detergent if you have soft water and select a shorter cycle to wash
the glassware and to get them clean.
White spots appear on dishes and glasses.| Hard water area can cause limescale
deposits.| Check water softener settings or fill status of salt container.
Black or grey marks on dishes| Aluminium utensils have rubbed against dishes|
Use a mild abrasive cleaner to eliminate those marks.
Detergent left in dispenser| Dishes block detergent dispenser| Re-loading the
dishes properly.
The dishes aren’t drying| Improper loading| Use gloves if detergent residue
can be found on dishes to avoid skin irritations.
| Dishes are removed too soon| Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can come out. Take out the
dishes until the inside temperature is safe to touch. Unload the lower basket
first to prevent the dropping water from the upper basket.
The dishes aren’t drying| Wrong program has been selected| With a short
program, the washing temperature is lower, decreasing cleaning performance.
Choose a program with a long washing time.
| Use of cutlery with a low-quality coating| Water drainage is more difficult
with these items. Cutlery or dishes of this type are not suitable for washing
in the dishwasher
WARNING
Availability Of Spare Parts
-
Seven years after placing the last unit of the model on the market:
Motor, circulation and drain pump, heaters and heating elements, including heat pumps (separately or bundled), piping and related equipment including all hoses, valves, filters and aqua stops, structural and interior parts related to door assemblies (separately or bundled), printed circuit boards, electronic displays, pressure switches, thermostats and sensors, software and firmware including reset software. -
Ten years after placing the last unit of the model on the market:
Door hinge and seals, other seals, spray arms, drain filters, interior racks and plastic peripherals such as baskets and lids.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>