Akitas C6 Vacuum Cleaner Instruction Manual

VACUUM CLEANER
INSTRUCTION MANUAL Model: C6

DESCRIPTION

A. Handle
B. Hose
C. Wind Force Adjuster
D. Tube
E. Floor brush
F. Hose connector
G. Dustbin
H. Cable Rewinder Button
I. Power Switch Button IMPORTANT
Read this instruction booklet carefully.

• Before using the appliance, check that the mains power voltage corresponds to the voltage shown on the rating plate.
• The appliance should be connected to a correctly-earthed 10 power socket.
• Always remove the plug from the power socket when the appllance is not in use and before carrying out any deaning or maintenance operations.
• Always remove the plug from the power sockci before opening the appliance.
• Never use methylated spirits or other solvents to clean the appliance.
• Do not use the appliance to vacuum liquids.
• Never leave the appliance unattended when it is switched on. Keep the appliance out ot the reach of children or the infirm.
• This applianceis for domestic use only. Use as described in this intruction booklet.
• Do not switch the appliance on if it appears to be faulty in any way.
• For repairs or accessories. Contact your dealer or an authorized Service Center.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

Do not remove the plug from by pulling the cable or the appliance itself
Do not run the appliance over the power cable
Do not use the appliance to  vacuum lighted matches,  cigarette ends or hot ash.

ASSEMBLING THE VACUUM CLEANER

Removing the flexible tube
Remove the plug from the cover socket. To release the flexible
Tube, press the button on the end of the tube and pull the tube firmly from the air intake duct.

INSTRUCTION FOR USE

1. Before using the appliance. unwind length of cable and insert the plug into the power socket. Do not extend the cable beyond the RED mark. To rewind the power cable. press the rewind button with one hand, and guide the other hand to ensure that it does not whip causing damage
2. Press the ON/OFF button to switch the appliance on .

Using the cleaning accessories

• Dual-position carpet/floor brush.
  Pos. 1: bristles extended. for hard floors Pos. 2: bristles retracted for carpets

Clean the dust

1. Lift the form cover and take out the dust cup.
2. Take out the foam from dust cup .
3. Clean off the dust inside the dust cup.

Clean the foam

1. Take out the foam when it’s setting dirtys
2. Clean it in the water .dry it naturally before next use.

Troubleshooting

BLOCKAGES — THERMAL CUT-OUT
This appliance is fitted with an automatically resetting thermal cut-out
If any part becomes blocked, the appliance may overheat and automatically cut out
If this happens, follow the below instructions in ‘looking for blockages’
Note: large items may block the tools or wand inlet, If this happens, do not operate the wand release catch, Switch off the machine and unplug, Failure to do so could result in personal injury.
Looking For Blockages
Switch Off and Unplug the appliance before looking for blockages. Failure to do so could result in personal injury.
Leave the machine to cool down for 1-2 hours before looking for blockages.
Beware of sharp objects when checking for blockages.
Clean any blockage before restarting.
Refit all parts securely before using.

Chelsea Company Limited
Corylus,Buttons Way,Chalfont St
Giles, HP8 4BPUK

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>