HOME DECORATORS COLLECTION HB Series 4 Light Pendant Harwood User Guide
- June 4, 2024
- HOME DECORATORS COLLECTION
Table of Contents
- HOME DECORATORS COLLECTION HB Series 4 Light Pendant Harwood
- Safety Information
- Warranty
- Pre-Installation
- TOOLS REQUIRED
- HARDWARE REQUIRED
- PACKAGE CONTENTS
- Installation
- Connecting the wires
- Assembling the fixture
- Operation
- Care and Cleaning
- Troubleshooting
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
HOME DECORATORS COLLECTION HB Series 4 Light Pendant Harwood
THANK YOU
We appreciate the trust and confidence you have placed in the Home Decorators Collection through the purchase of this 4- light pendant. We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs. Thank you for choosing Home Decorators Collection!
Safety Information
- Before starting the installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
- Consult a qualified electrician if you have any electrical questions or need to replace the driver.
- If you have any non-electrical questions about this fixture, please contact our Customer Service Team at 1-800-986-3460 or HOMEDEPOT.COM/HOMEDECORATORS
WARNING: Disconnect the power prior to removing or installing a light fixture.
Warranty
WHAT IS COVERED
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five (5) years from the date of purchase. This warranty applies only to the original consumer purchaser and only to products used in normal use and service. If this product is found to be defective, the manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling.
WHAT IS NOT COVERED
This warranty shall not apply to any product that is found to have been improperly installed, set up, or used in any way not in accordance with the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty material or workmanship. This warranty shall not apply to instructions supplied with the product. This warranty shall not apply to a failure of on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and specially disclaims any warranty, whether expressed or implied, of fitness for a particular purpose, other than the warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including but not limited to any labor/expense costs involved in the replacement or repair of said product.
Contact the Customer Service Team at 1-800-986-3460 or visit HOMEDEPOT.COM/HOMEDECORATORS
Pre-Installation
PLANNING THE INSTALLATION
Read all instructions before assembly and installation. Before starting the installation of the fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard.
NOTE: Keep your receipt and these instructions for Proof of Purchase.
TOOLS REQUIRED
HARDWARE REQUIRED
NOTE: Hardware not shown to actual size.
Part | Description | Quantity |
---|---|---|
AA | Thumb Nut | 2 |
BB | Small Hex Nut | 2 |
CC | Mounting Screw | 2 |
DD | Wire Nut | 3 |
EE | Fixture Screw | 2 |
FF | Mounting Bracket | 1 |
PACKAGE CONTENTS
Part | Description | Quantity |
---|---|---|
A | Canopy | 1 |
B | Short Tube | 2 |
C | Long Tube | 2 |
D | Glass Shade | 1 |
Installation
Mounting the hardware
- Thread the fixture screws (EE) into the provided holes of the mounting bracket (FF).
- Thread the small hex nuts (BB) onto the fixture screws (EE). Do not tighten the small hex nuts (BB) at this time.
- Pull the supply wires out from the outlet box and mount the mounting bracket (FF) to the outlet box (GG) using the mounting screws (CC).
- Place the canopy (A) over the outlet box and onto the fixture screws (EE).
- Adjust the fixture screws (EE) until they protrude out from the canopy (A) 1/4 in.
- Remove the canopy (A) and secure the position of the fixture screws (EE) by tightening the small hex nuts (BB) against the mounting bracket (FF).
Adjusting the length
- Use the different lengths of tubes (B & C) provided to determine which combination of tube (B & C) lengths is going to give you your desired length. You do not have to use all of the tubes.
- Feed the fixture wires from the glass shade (D), through the tubes (B & C), through the canopy (A).
- Screw the components together until they are secured and do not come loose.
Connecting the wires
NOTE: If you have electrical questions consult your local electrical code for approved grounding methods.
- Connect the black supply wire to the black fixture wire using a wire nut (DD).
- Connect the white supply wire to the white fixture wire using a wire nut (DD).
- Connect the supply ground wire to the fixture ground wire using a wire nut (DD).
- Add a cable tie below each wire nut to provide a more secure connection.
Assembling the fixture
NOTE: Do not exceed a 60 watt incandescent light bulb or equivalent CFL or LED bulb.
- Place the canopy (A) over the fixture screws (DD) and secure the canopy (A) with the thumb nuts (AA).
- Install a 60W Incandescent bulbs (HH) or LED or CFL equivalent into each socket of the main fixture body (D).
Operation
- Turn on power at the circuit breaker or fuse box.
- Turn the light switch on to activate the fixture.
Care and Cleaning
NOTE: Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.
EXTERIOR MAINTENANCE
- Use a dry or slightly dampened clean cloth and wipe the surface of the fixture.
INTERIOR MAINTENANCE
- Disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box.
- Use a dry or slightly dampened clean cloth to wipe the interior surface of the fixture.
Troubleshooting
Problem | Solution |
---|---|
The light will not turn on. |
- Make sure the power supply is on.
- Test or replace the switch.
- Check the wiring.
- Replace the light bulb.
The fuse blows or circuit breaker trips
when light is turned on.
|
- Check the wire connections.
Questions, problems, missing parts?
Before returning to the store, call Home Decorators Collection Customer Service
- 8 a.m. 7 p.m., EST, Monday Friday
- 9 a.m. 6 p.m., EST, Saturday
- 1 800 986 3460
HOMEDEPOT.COM/HOMEDECORATORS
Retain this manual for future use.
Please contact: 1-800-986-3460 for further assistance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>