SANOTO Baby Bath Tub Instruction Manual
- June 14, 2024
- SANOTO
Table of Contents
SANOTO Baby Bath Tub
Product instructions
WARNING
- This is not a lifesaving device. This baby float can be only used in shallow water and should be under the supervision of adults. NEVER leave a child unattended.
- This product is made of high-temperature resistant materials, 100°C /212°F hot water will not release harmful substances. But for the safety of the baby, first put cold water and then put hot water until the water temperature is about 36-38°C/96.8-100.4°F.
SPECIAL REMIND
- When the temperature is less than 8 °C/46.5°F in winter, please use the heater to soften the product for 2-3 hours before use and prolong the service life of the product.
Product Structure Diagram
Product Description
- Baby bathtub is made of non-toxic and environmentally friendly pvc material (polyvinyl chloride), and the product complies with CE production standard.
- This product has multiple inflatable bags, and each air bag must be fully inflated to make it 80% full.
- The bottom has a non-slip hip support design, which is soft and comfortable.
- This product is suitable for babies aged 0-5.
Inflation Step Instructions
- First inflate the side airbag 1 , then inflate the bottom airbag 2, next inflate the headrest support airbag 3 ,and finally inflate the anti-slip support airbag 4.
- (Please strictly obey the above inflating sequence to avoid over inflated.)
- Allow infants and young children to enter the water only after all safety checks are performed for 20 minutes.
- Remember to rinse it with clean water after use, hang it in a cool and dry place to ensure hygiene, and avoid placing it in the bathroom or exposing it to the sun.
Attention:
- Please do not leave your baby alone in the pool, please use it within the sight of adults.
- Please confirm whether there is any abnormality such as air leakage or damage before use. If there is any abnormality, please stop using it.
- Please do not drag the child after putting it in the pool.
- Do not drag after adding hot water to avoid damage.
- When adding water, put cold water first and then hot water until the water temperature is 34-38 degrees.
- Please do not put hot water above 50 degrees. Keep away from fire and sharp objects.
Gas Nozzle Instructions
Inflation Step
- After the inflation is completed, cover the air nozzle and press it into the air bag.
Deflation Step
Pinch the bottom of the air nozzle and release the air.
If you have any questions about this product, please contact us directly.
Email: andyultra@163.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>