Oasser P2A Large Capacity Air Compressor Instruction Manual
- June 14, 2024
- Oasser
Table of Contents
P2A
Large Capacity Air Compressor
Model:
LS4074
Operating Manual
Product Schematic Diagram
- Product
- LCD
- Selector Switch Of Start And Pressure
- Port
- LED Switch & Inflation Switch
- LED Light
- Battery Pack
- Air Hose
- Balls Pin
- Balloon Pin
- Charging Adaptor
Technical Parameters
Product item: | LS4074 |
---|---|
Product name: | Multi-function Cordless Tire Inflator |
Working voltage: | DC 12V |
Rate of work: | <96W |
Battery capacity: | 2000mAh |
Inflation efficiency: | 185/70R14 6Mins |
The maximum inflation: | 120PSI |
Pressure unit: | PSI. BAR. KPA . KG/CM* |
‘The length of hose: | 150mm:=10mm |
Operating temperature: | 0°C~60°C |
Product size: | 245mm155mm80mm |
The weight of product: | 850 |
Installation
- Please connect the air hose to the pump.
- Please connect the trachea to the car tire.
- please tighten the connection between the air hose and the tire.
Instructions
- Please connect one end of the hose with the air pump, and the other end is screwed into the tire valve core. For the French valve core, the adapter must be added.
- You should press the button to start this pump, and it will turn off by itself in 90 seconds or press the button for 5 seconds.
- Cycle press the *+” – button, it can be in PSL, BAR, KG/CM2 between the pressure unit conversion, the sereen displays the actual pressure. Point press is slow, and long press is fast. If the pressure is set and sereen will be flashing for 4 seconds, then press the “inflation switch” to operate it.
- It will stop automatically once the target pressure reaches.
- After inflation, please remove the air hose from the valve core and pump.
- The charging time of the air pump is about 4-3 hours.
Pressure unites | Lock-out state | Set state |
---|
| |
Attention
- High-pressure gas will generate heat during inflating. In order to ensure the good performance of the pump, it should not continually working for more than 10 minutes each time. After 5-10 minutes, the pump needs to stop to cooling for 15 minutes.
- If there is abnormal noise or excessive temperature from the pump, please turn it off immediately and let it cool for at least 15 minutes. Mind your hands when removing the air hose.
- Prevent the pump from getting wet by rain or water.
- If the pump is not used for a long time, please charge the battery every six months and store it in where is dry.
- Fully charge the pump before use
Operation is subject to the following three conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits.
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Correct Disposal of this product
**** This marking indicates that this product should not be disposed with
other houschold wastes throughout the EU. To prevent possible harm to the
environment or human health from M uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
Made in China
Documents / Resources
|
Oasser P2A Large Capacity Air
Compressor
[pdf] Instruction Manual
P2A Large Capacity Air Compressor, P2A, Large Capacity Air Compressor,
Capacity Air Compressor, Compressor
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>