truelife NannyTone VM Pocket Instruction Manual

June 15, 2024
truelife

TrueLife NannyTone
VM Pocket

NannyTone VM Pocket

Image 1: Parent unit

truelife NannyTone VM Pocket - Figure 2

Image 2:

truelife NannyTone VM Pocket - Figure 1

BOX CONTENTS

  • Parent unit (3× AAA rechargeable batteries inside the unit)
    Baby unit (3× AAA rechargeable batteries inside the unit)

  • 1× USB-C cable

  • Manual

DESCRIPTION OF PARENT UNIT

  1. Power LED indicator
  2. Power button (hold)
  3. Volume control
  4. Loudspeaker
  5. Clip
  6. Channel switch
  7. USB-C input
  8. Battery compartment

DESCRIPTION OF THE BABY UNIT

  1. Power LED indicator

  2. Power button (hold)
    Night light on/off (press)

  3. Night light

  4. Microphone

  5. Clip

  6. Channel switch

  7. USB-C input

  8. Battery compartment

GETTING STARTED

A) Parent unit

  1. Hold down the power button for 2 seconds and the parent unit will turn on.
  2. The green LED lights up when it is working properly.

B) Baby unit

  1. Place the baby unit close enough to the child.
  2. Hold down the power button for 2 seconds and the baby unit will turn on.
  3. The green LED lights up when it is working properly.
  4. Switch the channel to A or B to pair both units.

Attention: Keep cables out of the reach of children.
Danger of strangulation!
Attention: Do not use quick chargers to power the baby unit and charge the parent unit!
NIGHT LIGHT
To turn the baby unit night light on or off, press the power button on the baby unit.

RANGE

  • With increasing distance between the baby unit and the parent unit, the signal may be interrupted and thus the audio may gradually drop out. Loss of connection due to too great a distance from the baby unit will be indicated by the  parent unit flashing a red LED and beeping every 3 seconds.
  • The units have a tested distance of up to 50 m in the building and up to 700 m in the open.
  • The range is conditioned depending on the environment where the baby monitor is used. Thick walls, reinforced concrete structures or steel structures can reduce the signal in the same way as, for example, the signals of other  networks.

CHARGING THE PARENT AND CHILD UNIT

Use only the rechargeable batteries and cables that come included.

  • When the device is switched on, charging is indicated by a flashing green LED. When fully charged, the LED lights up green.
  • If the device is switched off, charging is indicated by a green flashing LED with the red LED continuously lit. When fully charged, the LED goes out.
  • If the battery is low, the LED will flash red and the unit will beep every 30 seconds.

BATTERY REPLACEMENT
Both units can be replaced with batteries. If replacement is necessary, follow the instructions in the manual.
a. Unscrew the rear cover of the unit with a screwdriver.
b. Remove the back cover.
c. Disconnect the old non-functional batteries by hand.
d. Insert the new working batteries by hand according to the drawing in the hole.
e. Screw back the back cover.

SPECIFICATIONS

Communication type: unidirectional
Frequency of two channels: 863.3 Mhz and 864.5 MHz
Range: 50 m in the building and 700 m in an open space
Parent unit battery life: 10–15 h
Baby unit battery life: 10–15 h
3× NiMH AAA 1.2 V rechargeable batteries for parent unit
3× NiMH AAA 1.2 V rechargeable batteries for the baby unit

MANUFACTURER’S LIABILITY

A warranty for manufacturing defects is provided for TrueLife products.
In case of such defects, elem6 s.r.o. is obligated to repair or replace the defective part or product with a comparable part or product at its own discretion. Transfer, change or any other unauthorized handling of the product are not covered  by this warranty. This includes situations that the product is lost or damaged due to a defect, negligence or other product faults. The warranty does not apply to damage following from use, accident or usual wear. Company elem6 s.r.o.  does not accept any liability for any accidents, injuries, death, loss or other claims related to or following from the use of this product. Under no circumstances shall elem6 s.r.o. be held responsible for incidental or consequential damage  related to or following from the use of this product or any of its parts. Returning or replacement of spare parts and/or the product may be subject to transportation, handling, replacement and/or completion fees.

SAFETY WHEN WORKING WITH THE DEVICE

  1. Carefully read the enclosed safety instructions.
  2. For proper handling of the product, download and read the latest version of the manual, which can be downloaded at:
    https://www.truelife.eu/.

Typing and printing errors are reserved.

MANUFACTURER:
elem6 s.r.o.,
Braškovská 15, 16100 Prague 6,
Czech Republic

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals