Razor W13111612030 Motor Replacement Instruction Manual

: June 15, 2024
: Razor

Table of Contents

Product Information
Instruction
WARNING
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Razor W13111612030 Motor Replacement

Product Information

The E100 Motor Replacement is a part required for maintaining and repairing the E100 electric scooter. It is designed to replacethe existing motor in case of damage or malfunction. The motor replacement instructions are provided in this user manual to guide users through the process of replacing the motor safely and effectively.

Before starting the motor replacement process, make sure to turn off the power switch and disconnect the charger to avoid potential hock or injury. Following the correct order of steps is crucial to prevent irreparable damage.
Using a Phillips screwdriver, remove the six (6) screws on the deck cover.
Using an 8 mm wrench, remove the two (2) lock nuts at the back of the deck cover.
If you are replacing the motor on the E100 Glow model,] disconnect the deck lights connector from the controller.
Using a Phillips screwdriver, remove the two (2) screws from the battery holder. Remove the deck cover and batteries from the tray and set them aside.
Using a Phillips screwdriver, remove the two (2) screws on the chain guard and remove the chain guard, setting it aside.
Using a Phillips screwdriver, remove the three (3) screws that hold the motor to the frame.
Disconnect the motor from the controller. Use a small pointy object to depress the locking pins from the prongs inside the connector and remove the connector from the wires.

If you need further assistance or have any questions, you can visit our website at www.razor.com or call our toll-free number at 866-467-2967">866-467-2967 during our customer support hours: Monday – Friday 8:00 AM – 5:00 PM PST.

Instruction

Required Tools: (Not included)

A. Phillips screwdriver
B. 8 mm wrench
C. Small pointy object

WARNING

CAUTION
To avoid potential shock or other injury, turn power switch OFF and disconnect charger before performing any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.

Step 1
Using a Phillips screwdriver, remove the six (6) screws on the deck cover (circled in the image below).

Step 2
Using an 8 mm wrench, remove the two (2) lock nuts at the back of the deck cover circled in the image below).

Step 3
This step is for the E100 Glow ONLY, disconnect the deck lights connector from the controller.

Step 4
Using a Phillips screwdriver, remove the two (2) screws from the battery holder (circled in the image below). Remove the deck cover and batteries from the tray and set aside.

Step 5

Using a Phillips screwdriver, remove the two (2) screws on the chain guard (circled in the image below) and remove the chain guard and set aside.

Step 6

Using a Phillips screwdriver, remove the three (3) screws that hold the motor to the frame (circled in the image below).

Step 7

Disconnect the motor from the controller and using a small pointy object, depress the locking pins from the prongs inside the connector and remove the connector from the wires.

Step 7

Reverse the procedures