BLACK BOX WTRCCC01 Wireless Guitar Transmitter Receiver User Manual
- June 4, 2024
- BLACK BOX
Table of Contents
BLACK BOX WTRCCC01 Wireless Guitar Transmitter Receiver
Products Map
How to operate
Turn on the power button ON the transmitter and receiver. The Led indicator status of the transmitter will turn to blue color, But The Led status of the receiver will still not light up
Press on the pair button of the receiver, And the Led indicator status will turn to green. Then it will be paired automatically. Please no worried that led color is different when unit (receiver and transmitter) is paired.
Connect the transmitter to your instrument output (like guitar etc), and connect the receiver to the unit where you want to send the signal (amplifier, pedal, audio interface etc)
Please turn off the power button of the unit（Both the transmitter and receiver）and put them back to the power case each time you use it.
Charging function
- If the unit’s battery is running low, The led indicator of unit (both receiver and Transmitter) will flash green.
- You can charge the wireless units directly by using the Micro‐B USB Y cable (included)
- When unit is fully charged, the charging function will be shut down automatically. The Led indicator of the unit will turn off when them fully charged.
Pair Mode
(One Transmitter and multiple receivers)
When using a transmitter, You can use multiple receivers
- Turn on the power button of the transmitter. Press the Pair button of the receiver, Then the led indicator of the receiver turns to green
- Press and hold the pair button of the transmitter for 2‐3 seconds, Then the Led indicator Will flash a while and start to the pairing mode. The led indicator of Transmitter will turn to blue (No Flash) after 25 seconds, Then Pair mode is completed.
Note: The Led indicator of the transmitter will only flash for 25 seconds, So Please completed this step within 25 seconds.
Notice
To recharge the power case, Please make sure that your power adapter has a power output of 5V and 1A (or higher)
Specifications
- UHFoperating frequency
- Low latency signal transmitting, Less than 5ms
- Frequency response 20HZ‐18 Khz
- Transmitter and receiver:3.7v/700mAh
- Battery run time 8 hours (approx)
- Range：30‐50 M (Empty environment）
Note:
The actual range is dependent on RF environment, including reflections,
interference and absorption
For any questions, Please mail us at CS@kawlita.com， We will reply to you as soon as possible.
What’s in box
- Receiver x 1 Transmitter X 1
- Micro‐B USB Y cable
- User manual
FCC STATMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>