Shenzhen Lingan Intelligent Technology IR10 Receiver Switch and Transmitter Instructions
- June 4, 2024
- Shenzhen Lingan Intelligent Technology
Table of Contents
Shenzhen Lingan Intelligent Technology IR10 Receiver Switch and Transmitter
Instructions
Specification
- Rated voltage: AC 100-240V 50/60Hz
- Rated current: 10A(Resistive load)
- Material: ABS+PC
- Humidity: S80%
Wiring diagram
Instructions
-
The receiver switch and transmitter of this set have been paired. After the wires are connected according to the wiring diagram, the transmitter can control the receiver.
-
If you want to pair with a new transmitter. long press the receiver reset button for five seconds until the receiver switch indicator blink.
-
Put the batteries(2*AA1LR06) into the transmitter, press and hold the transmitter reset button until the receiver switch indicator LED is solid on, which means that the pairing is successful and you can control it.
Note: The transmitter is not equipped with batteries.
One receiver (WK2RF) can be paired with 2 transmitters. When the third
transmitter is paired with the receiver (WK2RF), the first transmitter will be
covered
Installation
- Installation position: Wall or corner, 1.8m-2.4m above the ground V1.1
- Installation instructions and precautions
- Working temperature: 20~35°C.
-
Don’t face the heat or cold source.
-
Avoid direct sunlight.
-
Do not install in an unstable place.
-
Do not install against the metal wall.
-
Please avoid high-voltage line.
Settings
| On state time 30s
---|---
|
On state time 60s
| On state time 300s
|
On state time 360s
| Sensitivity:low
|
Sensitivity:high
Warning
- It is forbidden to use it on the bed
- It is forbidden to use this product in humid and high temperature conditions.
- The maximum power of the receiver (WK2RF) is 1 OA, excessive power usage is prohibited
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
FCC ID: 2AJK8-IR10
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>