Shenzhen Lingan Intelligent Technology KA2RF Remote Control Switch Instruction Manual
- June 4, 2024
- Shenzhen Lingan Intelligent Technology
Table of Contents
Lingan Intelligent Technology KA2RF Remote Control Switch
Instruction Manual
Remote control switch
Operation Instructions
Specification
Rated voltage: AC 100-240V 50160Hz
Rated current:10A(Resis0ve load)
Material: ABS+PC
Working temperature: -10-45°C
Humidity:180%
Wiring diagram
Instructions
-
The receiver switch and transmitter of this sot have been paired. After the wires are connected according to the wiring diagram, the transmitter can control the receiver.
-
If you want to pair with a new transmitter, long press the receiver switch button for five seconds until the receiver socket indicator blink, and then long press the Ire NSM letter. When the receiver socket indicator LED Is solid on. the pairing Is successful. One receiver can be paired with 2 transmitters.
-
Battery replacement: rotate the transmitter counterclockwise to remove the back cover and take out the battery
-
Transmitter equipped with batteries.The battery model: CR2025
Warning
- It is forbidden to use it on the bed.
- It is forbidden to use this product in humid and high-temperature conditions.
- The maximum power of (the receiver is 16A, excessive power usage is prohibited.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet the general RF exposure requirements. The device can be used in portable exposure conditions without restriction FCC ID: 2AJK8-KA2RF
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>