HOMCOM 820-281V70 Oscillation Tower Heater Instruction Manual
- June 15, 2024
- HOMCOM
Table of Contents
IN230900528V01_UK ES PT DE
820-281V70 820-281V90
AC
220-240V 50Hz 1300/2000W
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.
820-281V70 Oscillation Tower Heater
The display temperature mode can be switched : .
In standby mode, the Temp and ON/OFF keys are held down for three seconds to
switch between Degrees Fahrenheit and Degrees Celsius
peration chart
Function Introduction
- The use of electronic type
A. When plugged in, turn on the power switch on the back of the product, After hearing the “beep” sound, the digital screen displays the ambient temperature, and the product is in standby state at this time. B. ON/OFF: The first press will show blue Low, the second press will show red High, and the third press will turn off the product. C. Press the swing button to rotate or stop the product. D. Timer:1-24Hour
E. Temp: set the temperature to 59-104 Fahrenheit degree (15-40 Celsius temperature). In this working state, press the ON/OFF to cancel the temperature setting.
The product shuts down automatically when the ambient temperature exceeds 122 Fahrenheit degree(50 Celsius temperature) F. At the same time, long press the temperature button and the timer button for 3 seconds, It can be unlock or lock.
G. Long press the swing to rest the screen, turn off the light, and press any key to wake up.
H. Please remove the protective film before using the remote control. Please plug the diaphragm if it is not used for a long time.
This product is intended for indoor residential and office use only, not for
industrial or other commercial application. Use only with electrical wiring
that is in good working order and that meets applicable codes and ordinances.
This heater must be plugged into a 220-240V AC circuit. Do not pug anything
additional into the same circuit. If you have any questions whether your
wiring is adequate, consult a qualified electrician. Risk of fire
,overheating, malfunction, property damage, injury or even death result if not
adhered to Use your heater-fan only with a working smoke detector located in
the vicinity of your heater/fan.
While using your heater/fan, you should follow the IMPORTANT INSTRUCTIONS
listed below.
As part of those instructions, we have used the word “WARNING” to indicate the
level of hazard: WARNING indicates a hazard which, if not avoided, could
result in injury or death.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed
to reduce the risk of fire, electric shock and injury to persons, including
the following:
Read all the instructions before using this heater/fan.
This heater/fan is hot when in use. To avoid burns, do not let bare skin touch
hot surfaces. Use provided handle when moving this heater. Keep combustible
materials, such as furniture, pillows, bedding, papers, clothes and curtains
at least 0.9 meters from the front of the heater- fan and keep them away from
the sides and rear.
Do not use heater unattended. Use of extreme caution is necessary when any
heater is used by or near children, invalids, disabled persons or pets.
Do not operate the heater with a damaged power cord or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanical
adjustment or repair.
Do not use heater outdoors.
Use your heater only in dry environments. This heater is not intended for use
in a bathroom, laundry area, or similar locations, or near sinks, washing
machines, swimming pools or other sources of water. Never locate heater where
it may fall into a bathtub or other water container.
Do not use in damp environments such as flooded basements.
Do not place the heater on a small, unlevel, uneven or any surface which might
allow heater to tip or fall.
For proper operation, heater should be placed on a smooth, non-combustible
surface. Do not place on rugs, carpet, viny! flooring or other plastic
surfaces. Not for use outdoors or in wet areas.
This heater is not designed as a primary heat source.
Always plug heaters directly into a wall outlet/receptacle. Never use with an
extension cord or relocatable power tap (outlet/power strip).
Always unplug heater when not in use.
Do not run power cord under carpeting. Do not cover cord with throw rugs,
runners or similar coverings. Arrange cord away from traffic area where it
will not be tripped over.
To disconnect heater, turn controls off then remove plug from outlet.
Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire or damage the heater.
To prevent a possible fire, do not block air intakes or exhaust in any manner.
Do not use on soft surfaces like a bed, where openings may become blocked.
A heater has hot and arcing or sparking parts inside. Do not use it in areas
where gasoline, paint or flammable liquids are used or stored.
Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock or injury to
persons or property.
If you have any questions, please contact our customer care center.
Our contact details are below:
0044-800-240-4004
[email protected]
IMPORTER ADDRESS:
MH STAR UK LTD Unit 27, Perivale Park, Horsenden lane South Perivale, UB6
7RH
MADE IN CHINA
