R B Elettronica 3.CB1 Display Flap Angle Kit Instruction Manual
- June 13, 2024
- R B Elettronica
Table of Contents
Kit display flap angle 3.CB1
3.CB1 devices associated to sensors 3.86.004 enable to see flaps position on 2
scales composed from 10 led.
This system is completely independent from hydraulic or electrical plant of
flaps, so it can be fit on any boat.
System composition :
– 3.CB1 Panel indicator
– 3.86.015 voltage steady
– 3.86.004 sensors flaps indicator
Layout for link without steady voltage item 3.86.015
3.CB1 devices associated to sensors 3.86.004 enable to see flaps position on 2
scales composed from 10 led.
This system is completely independent from hydraulic or electrical plant of
flaps, so it can be fit on any boat.
System composition :
– 3.CB1 Panel indicator
– 3.86.015 voltage steady
– 3.86.004 sensors flaps indicator
Layout for link without steady voltage item 3.86.015
Steady voltage 3.86.015 guarantee to the device 3.CB1 and to the sensors
3.86.003 an uniform voltage 12 vdc, also if there are jolts and fluctuation on
the plant.
Setting Mode
This operation allow to the device to acquire the correct flaps stroke
– Completely fall both flaps blades
– Push key IS around for 5 seconds up till 2 central led will switch on it
acquire rate of flap down
– Raise flap’s blades
– Push key FS around for 5 seconds up till 2 central led will switch on it
acquire rate of flap up
– All led will turn on to indicate that flaps blade are lifted
– Falling flaps and check that all led will turn off
Sensors installation
WORKING PRINCIPLE
Sensors put on flaps surface, for an electro-inductive principle, “feel” and
transform the distance between them and flap’s metal blade in electric signal.
This signal will be sent to one or more display panels that eleborate and
digitize signal, display numerically correct position’s angle of flaps. It is
show on percentage of total stroke with values enclosed between “0” and “9”
for each blade.Sensor doesn’t work with plastic blade or not metallic
LINK
RED= 24VDC
YELLOW= 12VDC
GREEN= GROUND
WHITE= SIGNAL
INSTALLATION INSTRUCTION
Retract the flaps.
Loose screws nut that joint sensor to the brackets.
Fix the sensor to the stern using brackets AND
TAKE CARE THAT BASE OF SENSOR SUPPORTS PERFECTLY TO THE SURFACE OF FLAP
Avoid layer between hull and sensor. to obtain the best operating you have to
put the sensor closest axis of flap’s hinge.
Fix all screws and check that sensor’s base must be joint to flap’s surface.
If flap doesn’t have a smooth surface it will be necessary put metal plate
(made in alluminium or stainless steeljof any thicknessand with minimum size
of 100 X 80 mm. to fix and center the sensor.
Security systems and electronic components for yacht
Via Erba 42 20037 Paderno Dugnano (Ml)
tel. +39 02 99042670 ‘fax +39 02 9181203
info@rbelettronica.ccom
www.rbelettronica.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>