mattech ED35 Direct Fit Exhaust System Instructions
- June 13, 2024
- mattech
Table of Contents
INSTRUCTIONS
MAINTENANCE AND CLEANING
ENTRANCE MATTING
Regular maintenance is essential to prolong the appearance and efficiency of your mats. It is recommended to develop a maintenance schedule. The frequency will depend on the traffic and soil conditions.
INITIAL MAT USE
- Mats should be unrolled and laid flat a few hours prior to use.
- Normal shedding or “fuzzing” may appear on the surface of your new mat. This will disappear after a few vacuuming’s.
- To store mats once fully cleaned, roll them into their original boxes. Store flat in heated area.
PERIODIC MAINTENANCE
Entrance mats are used to capture dirt and debris before it is tracked into your building. However, mats must be cleaned regularly to extend their usefulness and appearance.
- Vacuum daily.
- 0na monthly basis summer use, apply a water-based carpet cleaner with sprayer and leave on for ten minutes. Extract surplus using a wet/dry vacuum.
- Ona weekly basis during peak winter use, apply a water-based carpet cleaner with sprayer and leave on for twenty minutes. Extract surplus using a carpet extractor or awed/dry vacuum.
- During peak winter use, if necessary, remove salt or ice Melter stains using a salt neutralizer following the manufacturer’s instructions. Repeat if needed.
ERGONOMIC MATS
Regular maintenance is essential to prolong the appearance and efficiency of
your mats. It is recommended to develop a maintenance schedule. The frequency
will depend on the traffic and soil conditions.
INITIAL MAT USE
1! Mats should be unrolled and laid flat a few hours prior to use.
2! Always make sure the floor is clean and non-greasy before laying mats.
PERIODIC MAINTENANCE
Anti-fatigue mats for dry environments
While properly maintained, anti-fatigue mats offer optimal performance.
- Shake or sweep daily to remove surface dirt
- Sweep the area underneath the mat of dirt and debris that could cause premature wear or loss of traction.
- Mats should be cleaned with a damp mop using a pH neutral, non-abrasive detergent.
- Allow the mat to completely dry before using
Anti-fatigue mats for wet and oily environments
- Shake or sweep daily to remove surface dirt
- Sweep and clean the area underneath the mat that could cause premature wear or Loss of traction.
- Mats can be cleaned with a pressure washer or gently scrubbed with a non-abrasive, water-based detergent
- Mats resistant to oils and greases must be occasionally cleaned with a water-based degreaser to eliminate excess oils. Never place in a commercial dishwasher.
Important
Never use rotary scrubbers or other mechanical cleaners or scrubbers. Do not
use solvents, pH detergents, or alkalis directly on the mat.
For more information, consult
www.mattech.ca
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>