RUGGED RIDGE JK XHD Winch Mounting Spacers Installation Guide
- June 13, 2024
- RUGGED RIDGE
Table of Contents
XHD Winch Mounting Spacers, JK
Part # 11540.15
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024
PHONE: 770-614-6101 | FAX:
770-614-6069
info@omix-ada.com
JK XHD Winch Mounting Spacers
Components
-
Spacer Blocks…………………………(2)
-
3/8-16 x 2.25″ Bolts………………..(4)
-
3/8 Flat Washer……………………..(4)
-
3/8 Lock Washer……………………(4)
-
Winch can be installed with the Bumper on or off of the vehicle. Remove any Hoops from the Bumper. Install Fairlead to Bumper.
Note – bolts for Fairlead (supplied with it) should pass from inside the Winch cavity, with the nut being installed on the outside.
Tighten Fairlead bolts.
-
Prepare Winch and vehicle for installation as specified in winch installation instructions. Align holes in bumper as shown below (Figure 1) with Spacers and winch mounting holes (Figure 2). It may be helpful to thread winch cable through Fairlead before bolting it in place. Install winch as instructed by winch manufacturer, but substitute standard bolts supplied with the winch for longer bolts supplied with the spacers.
-
Once all 4 Winch bolts have been started, tighten them. Installation of the Winch and the Winch Spacers is now complete! Proceed with the remainder of the installation as demonstrated in the main Bumper Installation Instructions.
Copyright © 2022 Omix-Ada® , Inc.
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST 1-800-449-6649
| EMAIL: techsupport@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>