CURT 51529-INS-RA Brake Control Harness and Brake Controller Instruction Manual
- June 13, 2024
- Curt
Table of Contents
CURT 51529-INS-RA Brake Control Harness and Brake Controller
Level of Difficulty
Easy
Installation difficulty levels are based on time and effort involved and may vary depending on the installer level of expertise, condition of the vehicle and proper tools and equipment
Wiring Location(s)
Under dash
Tools Required
Cutting tool Light
WARNING
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time
required.
All steps must be followed to ensure the product will function properly. Once
installed, test for proper function by using a test light or connecting a
properly wired trailer.
Maintenance
Periodic inspection of all wires and connections should be performed to ensure there is no visible damage or loose connections.
INSTALLATION INSTRUCTIONS
Step 1A – Palisade / Telluride
From under the dash on the driver side, locate the OBD2 or OBDII connector for vehicle diagnostics.
Step 2A – Palisade / Telluride
Step 3A – Palisade / Telluride
Follow the steps in the instruction manual included with your brake controller for installation and set-up
Step 1B – Santa Cruz
From under the dash on the driver side of the steering column, there is a 4-pin cream-colored housing. Install the custom brake control harness and brake controller into the housing.
Step 2B – Santa Cruz
Follow the steps in the instruction manual included with your brake controller for installation and set-up.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>