BETNEW X05 Bluetooth Audio Speaker Instruction Manual
- June 13, 2024
- BETNEW
Table of Contents
X05 Operating instructions
Product description
X05 is a Bluetooth audio product with Bluetooth +LINE IN+ charging bank function
Function operation instruction
-
Hold down:
I. Shutdown mode: Power on
li. Power on mode: Off -
Press and hold: Bluetooth mode: Reduce volume
LINE IN mode: Reduce volume
Tap: Bluetooth mode: Previous -
Press and hold: In incoming state: Reject the call
Tap: Play mode: Pause playback
Pause mode: Play music
Call status: Answer the call
Call status: Hung up
Double click: Bluetooth mode: Redial the call -
Press and hold: Bluetooth mode: Add volume LINE IN mode: Add volume Tap: Bluetooth Mode: Next
4.
Double click: TWS Pairing mode: Double click to enter TWS status at the same time
Function description:
When the device is turned on, it will automatically enter the Bluetooth pairing, then search with the Bluetooth device, when the search “veho MR7” is found, manually click the pairing on the device (the first pairing), and you can play the audio source on the device after the pairing is successful. After the device is powered on, the 3.5mm stereo audio plug will automatically enter the LINE IN mode after the 3.5mm plug on the other end of the audio cable is inserted into the device, and the audio source of the device can be played. -
Charging bank function: Insert the USB charging cable into the product OUT(USB) port at this time, the LED red light will light up. USB port output 5V 2A to charge the phone from right to left Represents 25% power, the second LED red light represents 50% power, the third LED red light represents 75% power, and the fourth LED red light represents 100% power
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>