THE FOAM COMPANY FOAMGDK Garage Door Insulation Kit Instructions

Kit Instructions

FOAMGDK Garage Door Insulation Kit

Garage Door Insulation Kit – How to Measure – Instructions

We cut all the insulation panels to size, length, width, and thickness. Essentially, you would measure the garage door sections to have the panels slotted in behind the flanges of the garage door. Please see the below simple steps to measure each section. Please ensure you measure each section as all might not be the same size.
For the length of the panels, from the inside of the flanges, you measure directly from left to right.
For the width, you would measure from up inside the top lip of each section to the top of the bottom lip. (Not to the inside of the bottom lip – as it would be impossible for the panels to slot in the cavity). As for the thickness, you would measure the depth of the slot into which the panels would be slotted. We would recommend adding 1mm onto the thickness to allow it to be snug/firm in place when installed (This is only optional). If/When the thickness, length, or width of the panel is slightly more and is not slotting in easily – sandpaper can be used to sand back a couple of millimeters to suit.
You can order your garage door insulation kit here (double or single): https://www.thefoamcompany.com.au/products/garage-door-insulation-kit

Please contact us directly, if you require any further information.

Kind Regards,
The Foam Company
The Foam Company | 1800 362 626 | www.thefoamcompany.com.au | info@thefoamcompany.com.au

References

• The Foam Company - Polystyrene | Polyethylene | Polyurethane Foams
• The Foam Company - Polystyrene | Polyethylene | Polyurethane Foams
• Garage Door Insulation Kit - Cut to Size - The Foam Company

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>