IWAVE SP3588 Splash-Proof Wireless Speaker Instruction Manual
- June 13, 2024
- iWave
Table of Contents
IWAVE SP3588 Splash-Proof Wireless Speaker
FUNCTION PANELS
![](https://manuals.plus/wp-content/uploads/2023/10/IWAVE-SP3588-Splash- Proof-Wireless-Speaker-Instruction-Manual-2.png)
| Power Switch Turn on/off
---|---
| Play/Pause Start and stop music
| Volume Down/Up Previous/Next Track
| Answer/Hangup Start and stop calls
Box include:
bluetooth speaker
Micro USB Charging Port
Bluetooth® CONNECTION
- Power the speaker on. The speaker will automat cally enter pairing mode when powered on.
- From your device’s Bluetooth menu, select “IW _SP3588” speaker
- When paired successfully, the device will make a tone to confirm the connection has been made.
- Remember to turn the speaker off after each use.
Note: The speaker will reconnect automat cally if your device has been paired previous y. Dep en ding on your device’s typo and configuration, manual reconnect on may be required each lime
CHARGING
- Using a Micro-USB cable (included), insert the jack into the port on back of unit and then plug the USB connecter into USB port on the power source.
- Charge the device until the red LED indicator turns off.
- Always disconnect the cable when charging s finished.
TROUBLE SHOOTING
No power
- Recharge your speaker using the micro· USB cable. If the problem persists, try using another micro-use cable.
No response from the unit
- Ensure your Bluetooth device supports an A2DP, AVRCP, or HFP profile.
- Check if both devices are paired and connected to each other.
- Restart the device and try to reconnect.
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed an used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. The transmitter by industry Canada. To reduce potential sad to interference to other users. the antenna type and its gain should be so chosen that the equivalent is tropically radiated power e.1.,.p is not more than that necessary for successful communicant on
Electronic and electrical devices disposal
This symbol indicate that electrical and electronic device is to be collected separately.
- This is designated for separate collection at an approprsate collection point do not dispose of as house hold waste .
- f the device use batteries they must be remove from the device and disposed in a approprsate collect on center .
- If the batteries cannot be removed do not attempt to do it yourself since it must be done by a qualified professional.
- Separate collection and recycling help conserve natural resources and prevent negative consequence for human health and the environment that might result from incorrect disposal .
- For information contact there toiler or the local authorities charge of management.
SPECIFICATIONS
Model No: SP3588
Working Distance: Approx. 33 ft
Playback Time: Approx. 2.5 Hours
Charge Time: Approx. 1.5 Hours
Speaker Output Power: 3 W
Speaker Impedance: 4 Ω
Battery: 300 mAh Lithium (rechargeable)
Customer Support
IWAVE and iwave logo are trademarks of argent SC
the bluetooth word mark and logos are registered trademarks owned by Bluetooth
signing and any use of such marks by argent license designed in USA made in
chine .
New York 10018
Support@argentosc.com
www.argentosc.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>