KINESIK Armor-Tile Tactile Walking Surface Indicators Instruction Manual

: June 13, 2024
: KINESIK

Table of Contents

Armor-Tile Tactile Walking Surface Indicators
Installation Instructions: .
Documents / Resources

Armor-Tile
Tactile Systems
Cast in Place
Tactile Walking Surface Indicators
Installation Instructions

Armor-Tile Tactile Walking Surface Indicators

NOTE: Tiles can be cut to custom sizes, or to make a radius, using a continuous rim diamond blade in a circular saw or mini-grinder. Use of a straightedge to guide the cut is advisable where appropriate.
Recommended Tools and Materials:

White, or non-marking rubber mallet
Sand bags
3/8” radius edging tool
Sharp exacto knife
Hard plastic bristle brush
Continuous rim diamond blade in a circular saw or mini-grinder.
Steel trowel

Installation Instructions: .

Maintaining a 4-7 slump range, pour and ﬂoat the concrete.
Without removing any concrete, place the tile 6-8″ from the curb line (face of curb).
IMPORTANT: Recess the tile installation by 3mm (+/-1mm) (Compliant to CSA B651-18) to reduce potential damage by snow clearing vehicles.
Tamp the tile in grid pattern across the top face, embedding the tile into the concrete using a white or (non-marring) rubber mallet or vibrate into place using a vibrating mechanism ﬁxed with a soft base such as wood, at least 1 foot square.
Place sandbags or 25lb weights on the tile to prevent ﬂoating.
Create an edge around the perimeter of the tile using a 3/8″ radius edging tool then ﬂoat the concrete around the tile’s perimeter using a steel trowel. 5.
NOTE: Using the 3/8” radius edging tool create a a weep channel from tile to curb to allow water to drain from the surface of the tile.
Apply a broom-ﬁnish to the surrounding concrete.
After the concrete has substantially cured, remove the protective plastic wrap by cutting the plastic with a sharp knife tight to the concrete/tile interface.
If concrete bled under the plastic, a hard plastic bristle brush will clean the residue without damage to the tile surface.

For more information about Advantage One Plates Tactile Walking Surface Indicators scan the QR code below:

https://kinesik.ca/armor-tile-cast-in-place/

Kinesik Engineered Products Inc.
855-364-7763
www.kinesik.ca

Documents / Resources

| KINESIK Armor-Tile Tactile Walking Surface Indicators [pdf] Instruction Manual
Armor-Tile Tactile Walking Surface Indicators, Armor-Tile, Tactile Walking Surface Indicators, Walking Surface Indicators, Surface Indicators, Indicators
---|---