Emerson EBT1000 Wireless Stereo Speaker Owner’s Manual

Owner’s Manual Wireless Stereo Speaker
EBT1000

In the box

Drive safe

Driving while talking on your mobile phone is dangerous, and illegal in many states.
Although this device enables drivers to conduct handsfree conversations, it is still dangerous to drive and use a mobile phone at the same time.
We recommend pulling over before making or answering calls, especially during adverse driving conditions. Please use your mobile phone,and our product responsibly while driving!

Location of controls

1. [ VOL+ ] button quick press = next song press & hold= volume up
2. [ MODE ] button quick press = Play/Pause/Answer Call/End Call
3. [ VOL-] button quick press = previous song press & hold= volume down
4. LED light
5. POWER OFF/ON J switch
6. 3.5 mm auxiliary cord jack
7. DC5V charging jack
8. Microphone

Charging the Bluetooth Speaker

1. Connect the small end of the Micro USB charging cord into the DC5V port on the side of the speaker.
2. Connect the other end of the Micro USB cable to your computer’s USB port.
3. The RED LED indicator light turns on.
4. The RED LED indicator light shuts off when the speaker is fully charged (approximately 4 hours).
   NOTE: When the battery is running low, the RED indicator light starts to flash.

NOTE: Make sure you charge your speaker for 8 hours before using it for the first time.

Pairing the speaker with a Bluetooth enabled phone

1. Make sure the Bluetooth Speaker is turned off.

2. Keep your Bluetooth Speaker and mobile phone within 3 feet of each other during the pairing process.

3. Slide the [ POWER OFF/ON] switch to the ON position, the LED light will flash BLUE 6 times quickly.

4. Quick press the [ MOOE] button, the LED will flash BLUE and RED alternately. The speaker is now in pairing mode.
   
   NOTE: To enter the Pairing Mode, you must tum ON the speaker, then quick press the [ MOOE] button after the BLUE light flashes 6 times quickly.

5. Set your mobile phone to search for Bluetooth devices.

6. When the phone finds the headset, confirm by selecting EBT1000 from the list

7. Enter passcode “0000” when prompted by the phone.
   OR depending on which model mobile phone you are trying to connect the speaker to, it may not be necessary to enter a passcode.

8. Your mobile phone will confirm that the pairing was completed, and prompt you to accept the connection.
   Please respond YES to connect the headset to your mobile phone. If the pairing was successful, the headset’s indicator light flashes BLUE every few seconds.

NOTE: The screenshots above are typical of many Bluetooth enabled phones in the market today, and are used to assist in the explanation of the pairing process. Your mobile phone’s interface and interaction with the Bluetooth Speaker  may slightly differ from the illustrations above.

Using your Bluetooth Speaker

Powering ON/OFF

• To turn ON, slide the [POWER ON/OFF] switch to the ON position, the LED flashes BLUE 6 times quickly then once every few seconds.
• To turn OFF, slide the [POWER ON/OFF] switch to the OFF position. The LED will turn RED and the speaker will power OFF.

Answering/Ending a call

• To answer a call, quickpress the [ MODE] button.
• To end a call, quickpress the [ MODE] button.

Adjusting the volume
Press &hold the [ r VOL +]or[ VOL -] button to adjust the volume to the desired level.
NOTE: You may also adjust the volume from your mobile phone’s volume control

To make a call
Dial the number and press the send button on your mobile
phone, the call is automatically transferred to the headset.

Redialing the last number called (Dependent on your phone supporting this feature)
Quick press the ( MODE] button twice. The last number called will be redialed.
Rejecting calls
To reject an incoming call, long press the[ MODE] button for 3 seconds.

Stereo Bluetooth

This speaker allows you to listen to (in full stereo) and control the music on your Bluetooth enabled mobile phone, computer or mp3 player and supports the following Bluetooth profiles:

• A2DP -Advanced Audio Distribution Profile
• AVRCP- Audio/Video Remote Control Profile
• HSP – Headset Profile
• HFP -Handsfree Profile

To use the speaker to listen/control music, your Bluetooth enabled device must support the A2DP and AVRCP profiles. Please refer to the user guide of your Bluetooth enabled device for more information.

Playing music

To enjoy wireless music on your Bluetooth Speaker, make sure you are connected to a Bluetooth enabled media device. Once connected, you can press PLAY on your Bluetooth device or you can press the [ MODE J button on the  EBT1000 Bluetooth Speaker. Once playback has begun, you can control the music or answer phone calls from the control buttons of the Bluetooth Speaker (Not all mobile phones support the control of music using Bluetooth).
NOTE: Most media enabled smart phones will display “connected to phone audio and media” when connecting to the Bluetooth Speaker. This means you can make phone calls and enjoy your music.
Adjusting the volume
Press and hold the [ VOL +]or [ VOL-] button to adjust the volume to the desired level.
NOTE: You may also adjust the volume from your mobile phone’s volume control.
Play/Pause
Press the [ MODE) button to pause the music. To resume music playback, press the [ MODE] button again.
**Skipping or searching songs***
(Dependent on your phone supporting this feature)
Press the [ VOL -] button to go to the previous song.
Press the [ VOL +] button to go to the next song.

1. [ VOL+] button quick press = next song press & hold = volume up
2. [ MODE ] button quick press = Play/Pause/Answer Call/End Call
3. [ VOL-] button quick press = previous song press &hold = volume down
4. LED light

Safety information

Check local laws regarding use of a mobile handset and wireless headset while driving. If you use the Bluetooth Headset while driving, ensure your attention and focus remains on your driving.
Observe all signs in the designated areas where some electronic devices or RF radio products are required to be switched off.
These could include airplanes. hospitals, blasting areas, and potentially explosive atmospheres.
CAUTION: Although this device enables drivers to conduct handsfree conversations, it is still dangerous to drive and use a mobile phone at the same time. Always keep your full attention on your driving.

Product maintenance

Power off this product when not in use.
DO NOT expose this product to water or other liquids.
DO NOT use abrasive dealing solvents to dean the Bluetooth Speaker.
If you wail not use the Bluetooth Speaker for long periods, be sure store it in a dry place, free from extreme temperature, humidity and dust.

FCC and telephone company information

FCC Part 15
This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable  protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful  interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference radio or television reception, which can be determined  by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Do not attempt to repair or modify this equipment.
Warning: Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

industry Canada

Operation is subject to the following two conditions: (1) This device may not cause interference and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
The term “IC:” before the certification/registration number only signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that  Industry Canada approved the equipment.

Warranty information

Limited Warranty
In the unlikely event that this product is defective, or does not perform properly, you may within ninety (90) days from your original date of purchase return it to the authorized service center for repair or exchange.
TO OBTAIN WARRANTY SERVICE:

• Provide proof of the date of purchase within the package (Dated bill of sale).
• Prepay all shipping costs to the authorized service center, and remember to insure your return.
• Include a return shipping address (no P.O. Boxes), a telephone contact number, and the defective unit within the package.
• Describe the defect or reason you are returning the product.
  Your product will be repaired or replaced, at our option, for the same or similar model of equal value if examination by the service center determines this product is defective. Products received damaged as a result of shipping will  require you to file a claim with the carrier.

The shipping address of the authorized service center is:
southern Telecom inc.
ATTN: Returns Department
14-C53rd Street
Brooklyn, NY 11232

Should you have any questions or problems concerning this product, please contact our customer service department at:

****1-877-768-8483 (Toll Free)
Monday – Thursday: 9AM- 5PM (EST)
Friday: 9AM – 3PM (EST)
or via e-mail at
cs@southerntelecom.com

Warranty service not provided
This warranty does not cover damage resulting from accident, misuse, abuse, improper installation or operation, lack of reasonable care, and unauthorized modification. This warranty is voided in the event any unauthorized person opens, alters or repairs this product. All products being returned to the authorized service center for repair must be suitably packaged.
Limitation of Warranty:

• THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES, EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF MERCHANTABIIJTY OR  FITNESS FOR A PARTICULAR PURPOSE) ARE HEREBY DISCLAIMED. NO VERBAL OR WRITTEN INFORMATION GIVEN BY SOUTHERN TELECOM INC AGENTS, OR EMPLOYEES SHALL CREATE A GUARANTY OR  IN ANY WAY INCREASE THE SCOPE OF THIS WARRANTY.
• REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER. SOUTHERN TELECOM INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL  DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. ‘THIS DISCLAIMER OF WARRANTIES AND LIMITED  WARRANTY ARE GOVERNED BY THE LAWS OF THE STATE OF NEW YORK. EXCEPT TO THE EXTENT PROHIBITED BYAPPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABIIJTY OR FITNESS FOR A  PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE.
  Some states do not allow the exclusion nor limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts so the above limitations or exclusions may not apply to you. This warranty gives you  specific legal rights, and you also may have other rights that vary from state to state.

www.emersonphones.com

Manufactured by Southern Telecom Inc. Brooklyn, NY 11232
O2012 Southern Telecom Inc. All rights reserved.
Emerson and the G-Clef logo are registered trademarks of
Emerson Radio Corp. Parsippany, New Jersey USA.
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc.

References

• Manual-Hub.com – Free PDF manuals!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>