FrSky PS30 ADV Pressure Sensor Instruction Manual
- June 13, 2024
- Frsky
Table of Contents
FrSky PS30 ADV Pressure Sensor
Product Information
The FrSky Pressure Sensor – PS30 ADV is a product designed for the FrSky Smart Port enabled system. It is capable of measuring pressure. The sensor has a measured range of 0~30 Bar (435 psi). It is compatible with other FrSky S.Port enabled sensors such as the Variometer Sensor, GPS Sensor, RPM Sensor, and Airspeed Sensor.
Specifications
- Measured Range: 0~30 Bar (435 psi)
- Dimensions: 27mm x 20mm x 35.5mm
- Weight: 46g
LED Status
- Flash slowly: S.Port enabled
- Flash quickly: FBUS enabled
Contact Information
-
FrSky Electronic Co., Ltd.
-
Website: www.frsky-rc.com
-
Email: [email protected]
-
Address: F-4, Building C, Zhongxiu Technology Park, No.3 Yuanxi
Road, Wuxi, 214125, Jiangsu, China -
Technical Support Email: [email protected]
Product Usage Instructions
- Connect the T-Connector to the pressure measuring head.
- Do not disassemble the pressure measuring head.
- Keep the circuit board away from water, vibration, or fuel.
- Connect the output port of the sensor to the receiver.
- Select S.Port/FBUS on the receiver setup screen.
- The sensor will automatically recognize and display the LED status accordingly.
For more detailed instructions, please refer to the corresponding receiver instruction manual or visit the FrSky website for support.
Introduction
Thank you for purchasing the FrSky Pressure Sensor – PS30 ADV. It is designed
for a FrSky Smart Port-enabled system and can measure pressure. In order to
fully enjoy the benefit of it, please read the instruction manual carefully
and set up the device as described below.
Note : All instructions, warranties, and other collateral documents are
subject to change at the sole discretion of FrSky Electronic Co., Ltd. For
further information, please visit www.frsky-rc.com
and click the support tab for this product.
Overview
Specifications
- Dimension: 37207mm (L×W×H)
- Weight: 2.9g
- Operating voltage: 4-10V
- Current drain: 5mA@5V
- Pressure measurement
- Measurement range: 0~30 Bar (435 psi)
- Overpressure: 50 Bar
- Safety pressure (T-Connector): 15Bar
- Compatible with FBUS/S.Port protocol
Set-Up
Pressure sensor – PS30 ADV is compatible with FrSky Smart Port-enabled receivers. Other FrSky S.Port-enabled sensors include a new Smart Port-enabled Variometer Sensor, GPS Sensor, RPM Sensor, Airspeed Sensor, and so on. For more details, please refer to the corresponding receiver instruction manual. All sensors could daisy chain with each other through their Smart Port. The ID number of the device could be changed by Free Link (Windows/android/ios).
Warning:
- Do not disassemble the pressure measuring head！
- Keep the circuit board away from water, vibration, or fuel.
LED Status
Connect the output Port of the sensor to the receiver, select S.Port/FBUS on the receiver setup screen, the sensor will automatically recognize.
| LED Status | S.Port | FBUS |
|---|---|---|
| Flash slowly | YES | NO |
| Flash quickly | NO | YES |
FrSky is continuously adding features and improvements to our products. To get
the most from your product, please check the download section of the FrSky
website www.frsky-rc.com for the latest updated
firmware and manualsFrSky Electronic Co., Ltd. www.frsky-rc.com Contact us: [email protected]
Add: F-4, Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi,
214125, Jiangsu, China Technical Support:
[email protected]