WARRIOR Sequential Front LED Indicators Instructions
- June 13, 2024
- WARRIOR
Table of Contents
Sequential Front LED Indicators
Instructions
Sequential Front LED Indicators
FITTING INSTRUCTIONS AND DIAGRAM FOR WARRIOR SEQUENTIAL FRONT LED
INDICATORS
CAUTION
Before fitting your LED indicators, please take the time to read through the
fitting instructions and to study the diagram to ensure you understand how to
mount and wire the indicators. If you are unsure in any way, please contact
your local garage or dealer for help.
FITTING INSTRUCTIONS
- Remove original indicators or drill holes if mounting in different place to OE indicators
- Unscrew the nut from the rear of the indicator and pass over wires
- Insert the LED indicators through the indicator mounting hole (Indicator spacers may be needed on some bikes).
- Thread nut back over the indicator wires
- Whilst holding the indicator in its desired position, re-tighten the nut (do not over tighten)
- Wire the indicators as per the wiring diagram below.
The resistors supplied with the indicators are ideal most vehicles fitted with
21W indicator bulbs (although some models may require an extra resistor to
give the proper flash rate). If you prefer to fit (or your bike is already
fitted with) an LED indicator flasher relay, then the supplied resistors will
not be required.
If used for extended periods (e.g. hazard lights), the resistors can get hot,
so it is preferable to mount the resistors against a heat resistant surface,
away from OE wiring looms.
Indicator adaptor leads are available separately for most motorcycles, should
you not wish to modify the wiring on your motorcycle
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>