hager WBMSLL Electronic Push Button Slave Switch Instructions
- June 4, 2024
- hager
Table of Contents
hager WBMSLL Electronic Push Button Slave Switch
Safety instructions
Electrical equipment may only be installed and assembled by a qualified
electrician in accordance with the relevant installation standards,
guidelines, regulations, directives, safety and accident prevention
regulations of the country. Failure to comply with these instructions may
result in damage to the device, fire or other hazards.
These instructions are an integral component of the product and must be
retained by the end user.
Design and layout of the device
The terminal block must be mounted in either its original shipped position or on the rear of the module by means of the enclosed cable tie.
- Button with status LED
- Retaining lugs for Rotoloc® fastening
- pre-assembled terminal leads
- Terminal block
Function
Correct use
- Extension unit to master devices WBMDUR, WBMDUPB und WBME5A
- Suitable for indoor use only, but no drip and no spray water.
- Suitable for Hager Rotoloc switch plates only
Product characteristics
- optional LED lighting by neutral conductor connection
Operation
The operation is to be taken from the instructions of the main device.
Information for electricians
Installation and electrical connection
DANGER!
Touching live parts can result in an electric shock.
An electric shock can be lethal.
Disconnect the connecting cables before working on the device and cover any
live parts in the area!
Connection diagram
- Neutral connection at the slave is only required for LED indication always on.
- Main device and extension unit must be installed on the same phase.
- Optional LED indication requires a neutral connection off the same circuit as the master it is connected to.
- Install a miniature circuit breaker of max. 10 A as device protection.
Technical data
- Operating voltage 230 V~ +/-10%
- Frequency 50 Hz
- Momentary-contact current > 10 mA
- Circuit breaker max. 10 A
- Degree of protection IP2X
- Power consumption
- Status LED Off < 0.07 W
- Status LED On < 0.3 W
- Extension unit cable length
- Load and extension unit cable
- in a common cable
- in separated cables
- max. 20 m
- max. 50 m
- Terminal block cables max. 2 x 1.5 mm²
- max. 1 x 2.5 mm²
- Flying leads, flexible 100 mm x 1,5 mm²
- Operating temperature -5 … 50 °C
- Storage temperature -20 … 70 °C
- Relative humidity (without condensation) 0 … 65 %
Troubleshooting
Undefined interferences during operation
Extension unit cable length too long or or a separated extension unit cable
has not been used. Adhere to extension unit cable length or use separate
extension unit cable if necessary
- End of life treatment of electrical/electronic equipment and batteries in the European Union countries.
The crossed-out ‘wheeled bin symbol’ marked on the equipment or its packaging, indicates that this product is not to be disposed off with unsorted municipal / household waste. Please check with your local authority or retailer for recycling and collection advice. This will enable you to contribute to the disposal, treatment and recycling in an environmentally sound way and help to prevent potential negative effects on the environment and human health.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>