HiFuture FutureMate Wireless Earbuds User Guide
- June 13, 2024
- HiFuture
Table of Contents
HiFuture FutureMate Wireless Earbuds User Guide
Unboxing
-
Future Mate
-
Manual
-
Magnetic charging cable
Summary of button functions
- MFB(Power ON, Volumes, Tracks, Play,Pause/Phone Calls, Voice Assistance)
- Volume Down/Previous Track
- Charging Port
- Speaker
- LED Indicator
- Microphones
Please fully charge the FutureMate before using.
Controls
Line No.| Desire Result| Require Action| Voice Prompts|
Indicator Light
---|---|---|---|---
1| POWER ON| PRESS“MFB”FOR 5 SEC.| Power on| Blue Blinks 1 sec.
2| POWER OFF| PRESS“MFB”FOR 5 SEC.| Power off| Red Blinks 1 sec.
3| PAIRING| After Power on| Pairing| Blue & Red Blinking
4| CONNECTED| After Paired| YoutaoreHciFountnuerected| Blue Blinks /15 sec.
5| DISCONNECTED| BluOetuotoothf dDisistaconnceneocrted| You
atroeHdiFcuotunrneected|
6| PLAY| DOULBLE PRESS MFB| /|
7| PAUSE| DOULBLE PRESS MFB| /|
8| PRE. TRACK| LONG PRESS“-”FOR 2 SEC.| /|
9| NEXT TRACK| LONGFOPRE2SSS“ECM. FB”| /|
10| VOLUME UP| SINGLE PRESS“MFB”| Max. Alarm|
11| VOLUME DOWN| SINGLE PRESS“-”| Min. Alarm|
12| ANSWER CALL| SINGLE PRESS“MFB”| /|
13| END CALL| SINGLE PRESS“MFB”| /|
14| REJECT CALL| LONGFOPRE2SSS“ECM. FB”| Voce bee|
15| BATTERY LOW| | Battery low| Red Blinks
16| CHARGING| | /| Red lights on
17| CHARGED| No connection for 5 min.| /| Blue lights on
18| AUTO OFF| or Charging| /| Red Blinks 1 sec.
19| DUT Mode| QuickwPhrielessP”oMwFeBr “O5ntime| /| Blue Blinking
20| RESET| Un“deMrFpBa”ir&i“ng-”stfaotru5s,selocnogndpsress| Power off|
Rfoerd1lisgehctounpd
Specifications
Bluetooth pairing name: FutureMate
Bluetooth version: Bluetooth 5.3
Bluetooth chip: AC7006F4
Supported protocols: HFP/A2DP/AVRCP
Connection distance: ≥12 meters
Battery type: 100mAh polymer battery
Music playback time: about 6 hours (100% volume)
Talk time: about 5 hours (100% volume)
Charging time: 1.5 hours
Speaker specification: 15.4MM±0.05
Speaker Impedance: 22Ω±15%
MIC sensitivity: -42±3dB
Charging
Recommend to use DC5V@1A Charger and factory magenetic charging cable to
charge FutureMate.
LED turns Red during charging, and it turns Blue after fully charged.
How to wear
Hang the headphone behind your neck with both speakers clinging to your ears. After that, adjust it until you feel comfortable.
Attentions
- Listening to music for an excessive long time mayake you feel uncomfortable, please try to use a medium volume instead of a big one.
- No matter how the volume is, please do not make it prevent you from hearing the surrounding sounds. Please take care when using the headphone.
- Do not throw, press the headphone or put it in the water.
- The headphone should keep away from fire, water and high voltage devices.
- It is not for children’s use as it contains small parts.
- Please do not treat it as domestic waste. Instead, send it to your electrical and electronic recycling station.
If there is any injury or property loss due to violation of the above contents, we will not bear any responsibility
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference:
- This device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.
MAKES LIFE MORE VALUABLE
Mods by ShenZhen Access Technology Co.,Limited
www.hifuturegroup
Designed in USA, Assembled in China
SHENZHEN FUTURE ACCESS TECHNOLOGY CO.. LTD. Wore more at www.hifuturegroup.ccm CM Rights Reserved
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>