Philips SHC5200 Indoor Wireless Headphones User Manual

Philips SHC5200 Indoor Wireless Headphones

What’s in the box

What’s in the box (Fig. A)

1. Headphones
2. Transmitter
3. AC/DC adaptor
4. Antenna tube
5. 2 x AAA rechargeable shortened sleeve NiMH batteries (SBC HB700L)

Get started

Note

• Before using the headphones for the first time, charge the supplied batteries for at least 12 hours.
• Only use Philips rechargeable shortened sleeve NiMH batteries with your headphones. Other types of rechargeable batteries cannot be charged with this system.
• AAA alkaline batteries can be used to operate the headphones, but cannot be charged with this system.
• If the volume of the audio source is insufficient, the transmitter automatically turns off.

1. Install/Replace supplied batteries (Fig. B).
2. Install the antenna tube into the transmitter (Fig. C).
3. Power on the transmitter (Fig. D).
   • Red LED is on when audio source is connected.
   • Red LED blinks if no audio source is connected for two minutes.
   • Red LED is off if no audio source is connected for four minutes.
4. To charge the headphones, connect the charging cable with the headphones (Fig. E).
   • Headphones: red LED is off during charge.
   • Transmitter: green LED is on during charge and is off when headphones are fully charged.
5. Power on the headphones and red LED is on (Fig. F).
6. Connect the audio device with the transmitter (Fig. G).
   • Red LED is on when audio source is connected.

Tip

• If there is interference, tune the transmitter and the headphones to the same channel (Fig. H).

Product version table

For further product support, please visit: www.philips.com/support

Register your product and get support at: www.philips.com/welcome

Download PDF:Philips SHC5200 Indoor Wireless Headphones User Manual

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>