Honeywell T4M Programmable Modulating Thermostat Installation Guide
- June 13, 2024
- Honeywell
Table of Contents
T4M Thermostat
Programmable Modulating Thermostat
Quick Start Installation Guide
T4M Programmable Modulating Thermostat
Compatible with Open Term appliances only.
Not compatible with 230V boilers, zone valve applications or 230V electric
heating.
Installation in 3 steps
Must be installed by a competent person.
To ensure your safety make sure the mains power is switched OFF before
accessing wiring.
Open Term Boiler
To prevent a short circuit from a loose wire
- When using multi-core cables: Only remove enough outer insulation to allow secure fixing of the cores into the terminal block.
- When using single core cables: Secure them together with a cable tie as close as possible to the terminal block.
-
Wire the Thermostat
Find a suitable wall location away from draughts, direct sunlight or other heat sources, and where cables can be run from the boiler to the thermostat. A) Separate the Wallplate from the thermostat, and using a screwdriver open the Wallplate terminal cover to connect wires. B) Connect wires according to wiring diagrams and clip the cover closed. -
Power Up and Test
Power Up the Heating System and do a quick functional test on the thermostat to check that it switches the boiler. -
Configure the System
Specific settings for the thermostat and heating system can be configured in the advanced menu.
Press and hold and then buttons together until the display changes (approx. 3 seconds). A) Press and buttons to navigate through the parameter list
B) Press and buttons to change a parameters
C) Press button to save the change (or press to cancel the change) D) Press button to exit advanced menu and save any changes
Parameters
| No | Description | Settings (default in bold) |
|---|---|---|
| Language | 1 = EN, 2 = NL, 3 = DE, 4 = FR, 5 = ES | |
| Lower Temperature Limit | 5 – 21 (°C) | |
| Upper Temperature Limit | 21 – 35 (°C) | |
| Schedule options | 1 = 7 day (different schedule each day of the week) |
2 = 5 + 2 day (weekday + weekend schedule)
3 = 1 day (same schedule every day)
| Number of periods per day| 4 or 6
| Wired Remote Sensor| 0 = No Remote Sensor, 1 = Wired Remote Sensor
| Fail Safe mode| 0 = Boiler off, 1 = Boiler 20% on / 80% off
| Backlight| 0 = Off, 1 = On (only on demand)
| Clock Format| 0 = 24 hr, 1 = AM/PM
| Daylight Saving time change| 0 = Off, 1 = Auto
| Temperature Display Offset| +/-1.5°C
| Restore Schedule Defaults| 0, 1 = reset
| Restore Factory Settings| 0, 1 = reset
| Low load control| 0 = Off, 1 = On
| Control setpoint| 5 – 99°C
| Supply water temperature| 5 – 99°C
| Return water temperature| 5 – 99°C
| Max. supply water temperature| 5 – 99°C
| Hot water temperature| 5 – 99°C
| Hot water setpoint| 5 – 99°C
| Actual power| 0 – 99%
| Water pressure| 0.0 – 9.9
| OTC control| 0 = Off, 1 = On
| OTC curve| 4 – 40 (16)
| Room compensation| 0 = Off, 1 = On
Troubleshooting
| What’s happening? | What it could mean… | How to fix it… |
|---|---|---|
| Thermostat display is blank | No power to heating system | Check heating system |
is powered
Faulty wiring connection| Check wiring at thermostat and boiler terminals
Display = | Faulty temperature sensor| Replace thermostat or check wiring to
remote temperature sensor if fitted
Thermostat shows heat demand
but boiler doesn’t respond| Boiler (water) already at temperature| Normal
behavior – wait for water temperature to drop
Faulty wiring connection| Check wiring at thermostat and boiler terminals
Conforms to protection requirements of the following directives:
EMC: 2014/30/EU and LVD: 2014/35/EU
ErP: Class VI (+4%), (EU) 811/2013
**** WEEE Directive 2012/19/EC – Waste Electrical and Electronic Equipment
directive
At the end of the product life dispose of the packaging and product in a
corresponding recycling centre. Do not dispose of the unit with the usual
domestic refuse. Do not burn the product.
Honeywell Control Systems Ltd.
Skimped Hill Lane,
Cracknell,
Berkshire
RG12 1EB
www.honeywelluk.com
Manufactured for and on behalf of the Environmental & Energy Solutions
Division of Honeywell Technologies Sàrl, ACS-E&ES, Z.A., La Pièce 16,
1180 Rolle, Switzerland by its Authorised Representative Honeywell Inc.
© 2016 Honeywell International Inc. | Printed in UK
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>