ATG LNS-4FT-25-T1-F-G2 Commercial Linear Strip Instruction Manual
- June 13, 2024
- ATG
Table of Contents
LNS-4FT-25-T1-F-G2
Commercial Linear Strip
Instruction Manual
LNS-4FT-25-T1-F-G2 Commercial Linear Strip
WARNING
- To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards read all warnings and instructions included with and on the fixture box and all fixture labels.
- Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
- Commercial installation, service and maintenance of luminaires should be performed by a qualified licensed electrician.
- For the installation: If you are unsure about the installation or maintenance of the luminaires, consult a qualified licensed electrician and check your local electrical code.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING
- Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
- Turn off the power when you perform any maintenance.
- Verify that supply voltage is correct by comparing it with the luminaire label information.
- All wiring connections should be capped with UL approved wire connectors.
CAUTION
- Avoid direct eye exposure to the light source while it is on.
- Account for small parts and destroy packing material, as these may be hazardous to children.
- Risk of burn. Disconnect power and allow fixture to cool before changing bulb or handing fixture.
NOTICE: Green ground screw provided in proper location.Do not relocate.
NOTICE: Minimum 90° supply conductors.
NOTICE: Specifications and dimensions subject to change without notice.
NOTICE: Suitable for Dry or Damp location
General Wiring Diagram
A: Chain Suspended Mounting (parts are sold separately)
- Take out the light fixture and accessories package from the box.
- Connect the V-hook to the lamp.
- Attach chain to the V-hooks.
- Connect the AC wires.
- The installation is completed.
B: Surface Mounting
- Take out the light fixture and accessories package from the box.
- Fix the baffle on the lamp.
- Open the module board down.
- Fix the lamp to the ceiling with the plastic sleeve and screws provided.
- Wire to mian power through the junction box.
- Assemble the module board upwards. The installation is completed.
Field-Adjustable Wattage & CCT
The end users may adjust the color temperature and lumen output respectively by the two DIP switch. Each DIP switch is accommodated with 3 options (left, middle and right ),corresponding to 3 color temperatures and 3 powers respectively, which can perform the desired color temperature and lumen output combination.
- DIP switches are located onto the side of the fixture.
- Select a wattage and color temperature by sliding switch left or right respectively to the desired value.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>