tp-link T120200-2B1 Gigabit VPN Router Instructions
- June 13, 2024
- tp-link
Table of Contents
tp-link T120200-2B1 Gigabit VPN Router
Product Information
- Product Name: Omada Pro 4G+ Cat6 AX3000 Gigabit VPN Router
- Model Number: G36W-4G
- Manufacturer: TP-Link USA Corporation
- Address: 10 Mauchly, Irvine, CA 92618
- Website : https://www.tp-link.com/us/
- Telephone : +1 626 333 0234
- Fax : +1 909 527 6804
- Email : [email protected]
Regulatory Compliance
FCC Compliance Information Statement
This device complies with part 15 of the FCC Rules. Operation is subject
to the following tw conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment. This device and its antenna must not be co-
located or operating in conjunction with any other antenna or transmitter. To
comply with FCC RF exposure compliance requirements, this grant applies only
to Mobile Configurations. The antennas used for this transmitter must be
installed to provide a separation distance of at least 42 cm from all persons
and must not be co-located or operating in conjunction with any other antenna
or transmitter.
CE Mark Warning
This is a class B product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.
Operating Frequency (Maximum Transmitted Power)
- 2400 MHz – 2483.5 MHz (20dBm)
- 5150 MHz – 5250 MHz (23dBm)
- 5250 MHz – 5350 MHz (23dBm)
- 5470 MHz – 5725 MHz (30dBm)
- WCDMA Band 1/3/5/8 (23dBm+1.7/-3.7dB)
- LTE Band 1/3/5/7/8/20/28/38/40/41 (23dBm+2.7/-2.7 dB)
Product Usage Instructions
Please follow the below instructions for using the Omada Pro 4G+ Cat6 AX3000 Gigabit VPN Router:
- Ensure that the router is properly connected to a power source using the provided I.T.E. Power Supply (Model Number: T120200-2B1).
- Connect the necessary antennas to the router, ensuring a separation distance of at least 42 cm from all persons and avoiding co-location or operation with any other antenna or transmitter.
- Place the router in an appropriate location, preferably in an uncontrolled environment, to comply with FCC RF radiation exposure limits.
- Ensure that the router is properly maintained and operated and that no unauthorized changes or modifications are made to the equipment.
- Refer to the user manual for further instructions on configuring and using the router for your specific network requirements.
Explanations of the symbols on the product label
Note : The product label can be found at the bottom of the product and its I.T.E. power supply. Symbols may vary from product.
Safety Information
- Keep the device away from water, fire, humidity, or hot environments.
- Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us.
- Do not use a damaged charger or USB cable to charge the device.
- Do not use any other chargers than those recommended.
- Do not use the device where wireless devices are not allowed.
- The adapter shall be installed near the equipment and shall be easily accessible.
- Use only power supplies that are provided by the manufacturer and in the original packing of this product. If you have any questions, please don’t hesitate to contact us.
- Operating Temperature: 0℃ ~ 40℃ (32℉ ~ 104℉)
- This product uses radios and other components that emit electromagnetic fields.
Electromagnetic fields and magnets may interfere with pacemakers and other implanted medical devices. Always keep the product and its power adapter more than 15 cm (6 inches) away from any pacemakers or other implanted medical devices. If you suspect your product is interfering with your pacemaker or any other implanted medical device, turn off your product and consult your physician for information specific to your medical device.
Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due to improper use of the device. Please use this product with care and operate at your own risk.
Regulatory Compliance
FCC compliance information statement
- Product Name : Omada Pro 4G+ Cat6 AX3000 Gigabit VPN Router
- Model Number : G36W-4G
Component Name| Model
---|---
I.T.E. Power| T120200-2B1
Responsible party:
TP-Link USA Corporation
- Address : 10 Mauchly, Irvine, CA 92618
- Website : https://www.tp-link.com/us/
- Tel : +1 626 333 0234
- Fax: + 1 909 527 6804
- E-mail: [email protected]
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note : The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located
or operating in conjunction with any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant applies to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 42 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.” We, TP-Link USA Corporation, have determined that the equipment shown above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change made in the equipment and the equipment is properly maintained and operated.
FCC compliance information statement
- Product Name : I.T.E. Power Supply
- Model Number : T120200-2B1
Responsible party:
TP-Link USA Corporation
- Address : 10 Mauchly, Irvine, CA 92618
- Website : https://www.tp-link.com/us/
- Tel : +1 626 333 0234
- Fax : +1 909 527 6804
- E – mail : [email protected]
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. We, TP-Link USA Corporation, have determined that the equipment shown above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change is made to the equipment and the equipment is properly maintained and operated.
CE Mark Warning
This is a class B product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.
- 2400 MHz -2483.5 MHz(20dBm)
- 5150 MHz -5250 MHz(23dBm)
- 5250 MHz -5350 MHz (23dBm)
- 5470 MHz -5725 MHz (30dBm)
- WCDMA Band 1/3/5/8(23dBm+1.7/‐3.7dB)
- LTE Band 1/3/5/7/8/20/28/38/40/41(23dBm+2.7/‐2.7 dB)
EU declaration of conformity
TP-Link hereby declares that the device complies with the essential
requirements and other relevant provisions of directives 2014/53/EU,
2009/125/EC, 2011/65/EU, and (EU)2015/863. The original EU Declaration of
Conformity may be found at https://www.tp-link.com/en/ce
RF Exposure Information
This device meets the EU requirements (2014/53/EU Article 3.1a) on the
limitation of exposure of the general public to electromagnetic fields by way
of health protection. The device complies with RF specifications when the
device is used at 20 cm from your body.
-
Frequency band: 5150 – 5250
-
MHz:
- Indoor use : Inside buildings only. Installations and use inside road vehicles and train carriages are not permitted.
- Limited outdoor use: If used outdoors, equipment shall not be attached to a fixed installation or the external body of road vehicles, a fixed infrastructure, or a fixed outdoor antenna. Use by unmanned aircraft systems (UAS) is limited to within the 5170 – 5250 MHz band.
-
Frequency band: 5250 – 5350
-
MHz:
- Indoor use : Inside buildings only. Installations and use in road vehicles, trains, and aircraft are not permitted. Outdoor use is not permitted.
- Frequency band: 5470 – 5725 MHz: Installations and use in road vehicles, trains, and aircraft and use for unmanned aircraft systems (UAS) are not permitted.
National restrictions
UKCA Mark
UK Declaration of Conformity
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of the Radio Equipment Regulations
2017. The original UK Declaration of Conformity may be found at https://www
.tp-link.com/support/ukca
National Restrictions
Attention : This device may only be used indoors in Great Britain.
Canadian Compliance Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
This radio transmitter (IC: 26583-ER706W4G/ Model: ER706W-4G) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this list below, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Antenna
- Wi-Fi: Three 5G 2dBi&2.4G 1dBi dual-band detachable antennas
- 4G : Two 800M 2.1dBi&2100M 3.9dBi dual-band detachable antennas
Caution:
- The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
- For devices with detachable antenna(s), the maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall be such that the equipment still complies with the e.i.r.p. limit;
- For devices with detachable antenna(s), the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limits specified for point-to-point and non-point-to-point operation as appropriate; and DFS (Dynamic Frequency Selection) products that operate in the bands 5250- 5350 MHz, 5470-5600MHz, and 5650-5725MHz.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
Industry Canada Statement
CAN ICES-3 (B)/NMB-3(B)
References
- Link: Simple, secure one-click payments
- CE Regulatory Compliance | TP-Link
- Regulatory Compliance | TP-Link
- WiFi Networking Equipment for Home & Business | TP-Link