Hertz 301HMRBT HMR BT Marine Bluetooth Receiver Instructions
- June 13, 2024
- HERTZ
Table of Contents
QUICK START GUIDE
Rev. 02
marine HMRBT
WATERPROOF BLUETOOTH RECEIVER
hertz-audio.com
301HMRBT HMR BT Marine Bluetooth Receiver
POWER FOR THE WAVES PURE MARINE CERTIFIED PRODUCT
The User’s Manual is also available on our web site www.hertz- audio.com
https://hertz-audio.zendesk.com/hc/en-gb/articles/9834189848081
BASIC OPERATION
WARNING: when the unit is turned on, starting and stopping the engine with its volume raised to the maximum level may cause hearing damage. Make sure you adjust the volume in advance.
Power On/Off
Note:
- Start the engine before using this unit.
- Be careful about using this unit for a long time without running the engine.
- If you drain the vessel battery, you may not be able to start the engine and this can reduce the service life of the battery.
1. Start the engine.
Engine ON position
2. Press to turn the unit ON.
INSTALLATION
BEFORE STARTING
- This device is exclusively for use in vessels with a negative ground 12/24 V power supply.
- Read these instructions carefully.
- Make sure the battery”- ” terminal is disconnected before starting.
This is to prevent short circuits during installation. (Figure 1)
INSTALLATION CAUTIONS
- In order to avoid any interference, do not install the unit in the proximity of the engine compartment.
- The use of unauthorized parts can cause permanent damage to the unit.
- Always check your wire connections to ensure proper installation before turning the unit on.
- Consult with your nearest dealer for proper installation or if other accessories are needed to complete the installation.
- Seek assistance if modifications or drilling holes to your vessel is needed.
- Do not install the unit where it will be subjected to excessive moisture, dust, dirt , foreign particles or vibration. Areas of high temperature from the engine, direct sunlight, or heat sources should also be avoided.
- Do not install the unit in a location where it will interfere with the vessel operation, or it will injure the passengers if there is a sudden or emergency stop.
Information on electrical and electronic equipment waste (for those
European countries which organize the separate collection of waste)
Products which are marked with a wheeled bin with an X through it can not be
disposed of together with ordinary domestte waste. These electrical and
electronte products must be recycled in proper facilities, capable of managing
the disposal of these products and components. In order to know where and how
to deliver these products to the nearest recycling/ disposal site please
contact your local municipal office. Recycling and disposing of waste in a
proper way contributes to the protection of the environment and to prevent
harmful effects on health.
Dimensions
SIZE
| A| A1| B| B1| C| D| E|
---|---|---|---|---|---|---|---|---
HMR BT| 73,2| 64,1| 63,7| 27,7| 39,1| 16.7| 55 ,8| mm
| 2.9| 2.5| 2.5| 1.09| 1.54| 0.66| 2.2| in.
MOUNTING
| Mounting Hole diameter mm(in.) | Ø 45 (1.77) |
|---|
Mounting
Precautions
WARNING: for your safety, while boating, keep the volume to a level at which external sounds can be heard.
-
This unit uses precision parts and components for its operation. In the event of any operating issues, never open the case or disassemble the unit. Contact your Hertz dealer or service center.
-
FCC STATEMENT
2.1 This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may cause undesired operation.
2.2 Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC ID: 2ASUD-HMRBT
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected .
• Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement. This equipment complied with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the unit & your body. -
The Bluetooth word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Elettromedia spa is under license. Other trademarks and trade names belong to their respective owners.
-
IC warning This device complies with Industry Canada’s license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1 )This device may not cause interference
(2)This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. The antenna should be installed and operated with
minimum distance of 20 cm between the radiator and your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
WARNING: changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
IC ID: 24882-HMRBT
Technical Specifications
BLUETOOTH
Specification| Bluetooth Version 5.0 with Qualcomm® aptX™ HD audio
Supported Profiles| ■ A2DP (Advanced Audio Distribution Profile)
■ AVRCP 1.5 (Audio/Video Remote control profile)
■ SSP (Simple Secure Pairing)
| ■ SSP (Simple Secure Pairing)
Connection Range| Up to 10m (30ft.)
Maximum range is achieved in line-of-sight installations,
actual range will vary based on installation specifics.
AUDIO
Line Max Output Level
@0.1 %THD| 4Vrms x 2 (L/R)
GENERAL
Operating Voltage| 8-28V dc
Grounding System| Negative Ground
Fuse rating| 2A (Mini ATC type)
Operating Temperature Range| -20° ( to 70° ( (-4° F to 158° F)
IP Protection| 1Px67 (IEC60529) **
Size (mm/in.)| 73,7 x 63,7 x 16,7 / 2.9 x 2.5 x 0.66
Weight (Kg /Lbs)| 0,153 / 0.338 (including the cable)
NOTE: Specifications and design are subject to change without notice for
further improvement.
**1Px7 Water Resistance Rating: This product has been tested to withstand
immersion in water, up to 1 meter (3.28 ft.) deep, for up to 30 minutes (when
properly installed). Note – while designed to be water resistant, this product
should – never be submerged under water for prolonged periods or subjected to
activity that creates pressure on it that exceeds — its depth rating.
BLUETOOTH: The Bluetooth® word mark and logos are registered trademarks
owned by Bluetooth SIG, Inc. and any use of such marks by Elettromedia sri is
under license.
aptX™ HD: Qualcomm aptx is a product of Qualcomm Technologies, Inc.
and/or its subsidiaries. Qualcomm is a trademark — of Qualcomm Incorporated,
registered in the United States and other countries. aptX is a trademark of
Qualcomm – Technologies International, Ltd., registered in the United States
and other countries and any use of such marks by
Elettromedia srl is under license.
PART OF ELETTROMEDIA
Strada Regina Km 3,500 – Marignano
62018 Potenza Picena (MC) Italy
T +39 0733 870 870 – F +39 0733 870 880
www.elettromedia.it
e1eccromeaia
UE DECLARATION OF CONFORMITY
| Name and Address of Manufacturer | Elettromedia s.p.a. |
|---|---|
| Brand Name | HERTZ |
| Model | HMRBT |
| Product | BLUETOOTH RECEIVER |
| Standards of Test | EMC DIRECTIVE – 2014/30/EU: |
EN 55032: 2015 + A 11 : 2020
• EN 55035: 2017 + A 11 : 2020
RED DIRECTIVE: 2014/ 53/ EU:
• ETSI EN 301 489-1 V2.2.3: 2019
• ETSI EN 301 489-17 V3.2.4: 2020
• ETSI EN 300 328 V2.2.2: 2019
• EN 62368- l :2020 + A 11 :2020
• EN 50663: 2017
• EN 62479: 2010
ROHS DIRECTIVE:2011 / 65/EU & 2015/863/EU
Reports N”| TZ22ll03830-RE
TZ221103830-BLE, TZ221103830-S, TZ221103830- EMF
CCl220800138EN
I, the undersigned, as legal representative of the company Elettromedia, declare that the equipment complies with the directives and standards mentioned above.
Potenza Picena 14/12/2022
Elettromedia Sri
Maurizio Riccobelli
Legal Representative
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>