TRANSGO JF010E Secondary Pulley Regulator Valve User Manual
- June 13, 2024
- TRANSGO
Table of Contents
TRANSGO JF010E Secondary Pulley Regulator Valve
Product Information
- Product Name: JF010E-SPR (Secondary Pulley Regulator Valve)
- Function: Corrects, prevents, and reduces trouble codes related to secondary pulley pressure and incorrect gear ratio.
- Compatible with: Nissan JF010E / RE0F09A / B 07-12 Altima 3.5L, 07-15 Maxima 3.5L, 02-16 Murano 3.5L, 10-16 Quest 3.5L
Product Usage Instructions
- Step 1: Discard the original SPR Valve and spring.
- Clean the New SPR Valve provided and test fit it into the clean VB bore. If it moves freely, remove it.
- Put a small dab of assembly gel into the groove of the new valve.
- Place the NEW Scarf Cut Ring on top of the assembly gel.
- Roll the new O-ring provided on top of the scarf cut ring.
- Place the assembled parts in the freezer for 15 minutes to size the ring into the groove. Note: The O-ring is only used as a sizing tool.
- Reuse the retainer and end plug from the original valve.
- Install the new Secondary Pulley Reg Valve into the VB bore.
- Refer to the next three pages for VB data (dated 9/17/20).
- Refer to Page 1 of the VB data for information on the new white spring (dated 9/17/20).
Please follow these instructions carefully to ensure proper installation and functionality of the JF010E-SPR.
HOW TO USE
-
Step 1. Discard original SPR Valve and spring. Clean the New SPR Valve provided and test fit it into the clean VB bore. If it moves freely, remove it and put a small dab of assembly gel into the groove of the new valve followed by the NEW Scarf Cut Ring. Now roll the new O-ring provided on top of the scarf cut ring and place it in the freezer for 15 minutes. This will “size” the ring into the groove.
Note: The O-ring is only used as a sizing tool.
-
Step 2. To install, roll the O-ring off the valve and set it aside. Insert the NEW White Spring into the hollow end of the new valve and insert new valve and spring into the bore while it’s still cold, followed by the original End Plug & Retainer. It will go right in IF the outer diameter of the ring is flush with the new valve. Never force the valve into the bore. Once you install the valve and ring– DO NOT REMOVE THEM!
Body Data
JF010E Valve Body Data
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>