Anker 312 Charger (20W II) A2149 User Manual
- June 13, 2024
- Anker
Table of Contents
Anker 312 Charger (20W II) A2149
USER MANUAL
Attention
Read all the instructions before using the product
- The product is designed for use with IT equipment only.
- The maximum ambient temperature during use of the appliance must not exceed 25°C.
- Naked flame sources, such as candles, must not be placed on the product.
- The disconnection from line voltage is made by AC plug.
- In case of broken plugs, the product must be disposed of.
- If you want to clean the product, only use a dry cloth or brush.
- The socket-outlet shall be installed near the equipment and shall be easily accessible.
- The power supply is not intended to be repaired by service personnel in case of failure or component defect (the product can be disposed of).
Using Your Product
For the fastest and safest charge, use an Anker® cable, your device’s original cable or another certified cable (such as MFi).
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to
radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
(4) Consult the dealer or an experienced radio / TV technician for help.
The following importer is the responsible party (for FCC matters only).
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1 (800) 988 79733
This device complies with Industry Canada license-ICES-003. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
IC Statement
This digital apparatus complies with CAN ICES-003(B)/NMB-003(B).
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A2149 is in
compliance with Directive 2014/35/EU & 2014/30/EU & 2011/65/EU & 2009/125/EC &
2019/1782/EU. The full text of the EU declaration of conformity is available
at the following internet address: https://www.anker.com
Hereby, Anker Innovations Limited declares that the product type A2149 is in
compliance with Electrical Equipment (Safety) Regulations 2016 &
Electromagnetic Compatibility Regulations 2016 & The Restriction of the Use of
Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations 2012 & The Ecodesign for Energy-Related Products Regulations 2010.
The full text of the GB declaration of conformity is available at the
following internet address:
https://www.anker.com.
- Indoor use only
- This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich, Germany
Anker Technology (UK) Ltd
Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA, United
Kingdom
Specifications
Input | 100-240V~0.7A 50-60Hz |
---|---|
Output | 5.0V 3.0A 15.0W / 9.0V 2.22A 20.0W |
Average active efficiency | 84.39% |
Efficiency at low load (10%) | 75.00% |
No-load power consumption | 0.03W |
Customer Service
- 18-month limited warranty
Please note that your rights under applicable law governing the sale of consumer goods remain unaffected by the warranties given in this Limited Warranty
- Lifetime technical support
support@anker.com
support.mea@anker.com (For Middle East and Africa Only)
(US) +1 (800) 988 7973 Mon-Fri 9:00 – 17:00 (PT)
(UK) +44 (0) 1604 936200 Mon-Sun 6:00 – 14:00
(DE) +49 (0) 69 9579 7960 Mo-Fr 6:00 – 11:00
(Middle East & Africa) +971 42463266 Sun-Thu 9:00 – 17:30
(UAE) +971 8000320817 Sun-Thu 9:00 – 17:30
(KSA) +966 8008500030 Sun-Thu 8:00 – 16:30
(Kuwait) +965 22069086 Sun-Thu 8:00 – 16:30
(Egypt) +20 8000000826 Sun-Thu 7:00 – 15:30
(AU) +61 3 8331 4800 Mon-Fri 8:30 – 17:00 (AEST)
(TR) +90 0850 460 14 14 Mon-Fri 9:00 – 18:00
(RU) +8 (800) 511-86-23 Mon-Fri 9:00 – 18:00 (MSK)
( 中国) +86 400 0550 036 周一至周五 9:00 – 17:30
( 日本) 03 4455 7823 月- 金 9:00 – 17:00
( 한국 ) +82 02-1670-7098 월 – 금 10:00 – 17: 00
For FAQs and more information, please visit:
anker.com/support
DOWNLOAD
Anker 312 Charger (20W II) A2149 User Manual – [Download PDF]
Anker 312 Charger (20W II) A2149 DoC – [Download PDF]