AIRTHEREAL FL-101S Flowless Water Leak Detector User Manual
- June 13, 2024
- AIRTHEREAL
Table of Contents
AIRTHEREAL FL-101S Flowless Water Leak Detector
PRODUCT STRUCTURE DIAGRAM
Water Leak Detector
Airthereal Water Leak Detector sounds an alarm after detecting water drips or
leaks.
After connecting to Wi-Fi, it instantly sends alert notifications to the app
wherever you are. *433 is a communication protocol with a frequency of 433MHz.
Note: Obstacles or products of the same frequency (433MHz) will affect the
reception of information.
SPECIFICATIONS
Water Leak Detector
Model: FL-101S
Sensor Contact: Detect water drip
Sensor Contact: Detect water leak (0.5mm)
Test Button: Pause alarm / Adjust volume
Batteries: 2 x AAA Battery
Alarm Volume: 120dB
IP Waterproof Rating: IP66
PACKING LIST
- 2 X Water leak detector
- 4 X AAA battery
- 1 X User manual
SET UP AND OPERATION
Setting Up the Water Leak Detector
Step 1 Install the battery
Step 2
Press the button [Test], and the detector will beep. Press again to pause the
alarm. Note: If there is no beep, open the back cover to check whether the
positive and negative directions of the battery are installed correctly.
Step 3
Adjust alarm volume by pressing and holding the test button for 3 seconds.
Press and hold for 3s each time to adjust one level of volume.
4 (DiDiDiDi-maximum sound)
3 (DiDiDi)
2 (DiDi)
1 (Di-mute)
Step 4
Test that the device can detect water. The detector will alarm if you drip
some water on the sensor contacts or put it on a wet surface.
Note: There are four detection sensors on the bottom of the device. Two
detection sensors in parallel lines will immediately alarm when they detect
water. Two sensors in diagonal lines will not alarm when they detect water at
the bottom of the detector.
Step 5
Press the test button to stop the alarm. Remove the device from the water and dry the sensors to stop the alarm completely.
- The first alarm will last for 15 seconds. If the sensor alarm ends and there is still water, the sensor will continue to alarm every 15 seconds until dry or you press the test button to end.
- When the detector is still immersed in water after 24 hours, the detector will stop the alarm.
INSTALLING YOUR DEVICE
- Plug the gateway into a power outlet or use the battery supply.
- Lay the water leak detector flat where you want to detect water leaks.
Note: Keep the distance between the gateway and the detector less than
100m/328ft.
LOW BATTERY REMINDERS
Gateway
When the gateway battery voltage is lower than 3.6V, the warning light will
flash 3 times every 40 seconds and buzz three times. The App will also send a
low battery reminder.
Detector
The detector will beep three times and send a low power signal to the gateway,
gateway alarm. (this action is only done once).
When the battery power is low, it will automatically shut off and prompt the
user to replace the battery.
If you press the [Test] button and the detector doesn’t emit a beep, it means
the battery is dead.
LIMITED WARRANTY
Airthereal warrants all Gateway and Detector for 1 year. For more information please visit www.airthereal.com/warranty.
What’s covered?
Defects due to faulty materials and/or workmanship of the product.
What’s NOT covered?
- Damage caused by the owner when attempting to fix or altering the product by himself or herself.
- Damage caused by misuse, abuse, neglect, alterations or unauthorized repair.
- Natural depreciation.
Warranty Period
Warranty becomes effective from the date of original purchase and will last
for 1 year.
Who’s covered?
This limited warranty is only effective for the original purchaser. It is non-
transferable.
How to request warranty services?
To obtain the benefit of this warranty, please email
support@airthereal.com.
Our customer service team will address your issue as soon as possible!
Always here to help you
www.airthereal.com
Produced for: West Ryder Technology LLC
2330 Paseo Del Prado STE C304
Las Vegas, NV 89102
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>