AUDIO SYSTEM XFIT-OPEL-MOKKA-X-EVO2 Speakers User Manual
- June 4, 2024
- AUDIO SYSTEM
Table of Contents
AUDIO SYSTEM XFIT-OPEL-MOKKA-X-EVO2 Speakers
Thank You
Congratulations on purchasing a high-quality AUDIO SYSTEM product incl. GERMAN
SOUND. Important: Completely read this operating instruction before
installation and use of the device.
Attention: Pay attention to advices and instructions of the car
manufacturer. Check the polarity when connecting the speakers.
Important: You will need your purchase receipt as proof of purchase for
any and all warranty repairs and for insurance purposes. Keep your receipt,
owner´s manual and packing materials in a safe location for possible future
use.
Attention: Use of sound components can impair your ability to hear
necessary traffic sounds and may constitute a hazard while driving your
automobile. AUDIO SYSTEM Germany accepts no liability for hearing loss, bodily
injury or property damage as a result of use or misuse of our products. We
recommend installing the equipment by an authorized service center or dealer.
A professional fitting and connection is the requirement for further warranty
and perfect sound.
Mechanical Installation Tip
Warning: First disconnect negative pole of your car battery. Check-polarity,
changing polarity may cause serious damage to your car electric. Best speaker
positions are the original build in positions. Easy installation and original
look are the reasons. Please note that the speakers are installed flat and
stable. The quality of the installation decides very much the sound,
therefore, attention should be paid to insulation and care during
installation. Please note that the speakers are protected from heat, sunlight,
mechanical influences, moisture and wetness by accessories from AUDIO SYSTEM.
Attention: Install all cables as straight as possible without squashing
or laying them over sharp edges. Otherwise this can cause short circuit or
damages to your whole installation. Attention: Be careful removing original
plastic parts of your car. The fitting parts could be damaged and have to be
replaced. Important: The right polarity of all speakers is extremely important
for the sound of your car audio system. We recommend changing polarity of the
tweeter finding out the best possible sound. The best is to listen and/or to
measure it.
Install Tweeter Mounting
Important: The enclosed mounting bracket is needed to install the tweeter in certain vehicles / mounting positions. For this, the tweeter must be fixed in the tweeter, this is from both sides possible.
Tweeter (Crossover FWK TW EVO)
Important: The speaker system can be adapted to the particular acoustics of
the vehicle, the genre of music and to personal taste via the crossover.
Depending on the position of the speakers, the switch can be adjusted so that
the frequency response is optimized with these geometric conditions. Depending
on the installation location of the tweeter, it is necessary to adjust the
frequency response tonal and volume technology, e.g. when mounting the tweeter
in the A-pillar, in the mirror triangle or in the door trim.
Attention: Free cable ends must be isolated. Non-compliance can lead to a
short circuit!
Sound (Crossover FWK MW)
Please connect the crossover FWK MW with CONNECTOR 017. It is a non- configurable fixed crossover.
Rain Protection MBR165
Please attach the rain protection MBR165 between speaker adapter LSR OPEL1 and speaker AS 165 EM EVO. The water cap must be upward of the magnet. In some cases the rain protection has to be cutted for proper fitting with a suitable tool (scissor, cutter, etc).
Optional Mounting Accessories
- ALUBUTYL 1500, 2000 EVO and 3000 EVO, ALU 250 EVO Self Adhesive Damping Material
- Damping: Doorkit 1.0 and Doorkit 2.0
- Z-(T)SC 0.75, 1.5, 2.5, 4.0 Oxygen-Free Speaker Cable
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>