PROFLO PFTS34CP Diverter Tub Spout Bathtub Pourer Instruction Manual

PROFLO PFTS34CP Diverter Tub Spout Bathtub Pourer

Product Information

The product is a faucet that requires installation. It is important to follow the provided instructions for proper installation and care in order to maintain the finish and functionality of the faucet.

Product Usage Instructions

1. Before removing an existing faucet or replacing any part of the faucet, always turn off the water supply. This can be done by accessing the shut-off valve for the water source and closing it.

2. Open the faucet handle to relieve any water pressure and ensure that the water is completely shut off.

3. To preserve the finish of the faucet, it is recommended to apply non-abrasive wax. This will help protect the surface from scratches and maintain its appearance.

4. If using any cleaners on the faucet, make sure to rinse them off immediately. Avoid using abrasive cleaners as they can damage the faucet’s finish.

5. For the installation process, you may need the following tools: a wrench, groove joint pliers, an adjustable wrench, a Phillips screwdriver, and sealing tape.

6. Slip on the spout over a 1/2  copper or CPVC pipe. Make sure the spout is tight against the wall.
   Tighten the set screw to secure the spout to the pipe.

7. Followany additional assembly instructions provided in the user manual  for further installation steps.

Please note that these instructionsare a general guide and may vary depending on the specific model and brand of the faucet. Always refer to the provided user manual for accurate and detailed instructions specific to your product.
Caution-Tips:
Always turn off water supply before removing existing faucet or replacing any part of the faucet. Open the faucet handle to relieve water pressure and ensure that water is completely shut off.

Care Instructions

To preserve the finish of your faucet, apply non-abrasive wax. Any cleaners should be rinsed off immediately. Do not use abrasive cleaners on the faucet.
You may need

• Goggles
• Wrench
• Groove joint plier
• Phillips screwdriver
• Sealant Tape

Mounting

• Slip on spout (1) over 1/2″ copper or CPVC pipe. Slide the spout over the pipe with the spout tight to the wall, tighten the set screw (2) to the pipe.

* Specify Finish

1. Spout assembly          PFTS34**

FERGUSON.COM/PROFLO

References

• PROFLO®

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>